Specifications.16 - Kenwood DP-R895 Instruction Manual

Specifications
[Format]
System —..—Compact disc digital audio system
Laser.....Semiconductor laser
Number of channels.—...2 channels
Playing rotation.—--200 rpm - 500 rpm (CLV)
[D/A convertors]
D/A conversion
Oversampling
Dynamic range --More than 94 dB
Total harmonic distortion + noise
....Less than 0.007 % (at 1 kHz)
Channel separation.——Morethan 90 dB (at 1 kHz)
Wow flutter -.-—™—.Unmeasurable limit
Output level/impedance
Fixed -----—^"""""2.0 V/3.3 kt2
—Bit
•8 fs (352.8 kHz)
[Audio]
Frequency response •
Signai to noise ratio *
[General]
Power consumption ■
Dimensions.
™4Hz-20 kHz, ±1.0 dB
--.—More than 96 dB
Weight (Net}
..low
™,W:440 mm (17-5/16")
H : 128 mm (5-1/16")
D ; 392 mm (15-7/16")
-5.0 kg (11.0 Ib)
KENWOOD follows a policy of continuous advancements in development. For this reason specifications may be changed without notice.
For CANADA
DOC REGULATION
"This digital apparatus does not exceed the CLASS B limits for radio noise emissions from digital apparatus as set out in the radio interference
regulations of the Canadian Department of Communications".
For the U.S.A.
FCC WARNING
This equipment may generate or use radio frequency energy, Changes or modifications to this equipment may cause harmful interference unless
the modifications are expressly approved in the instruction manual. The user could lose the authority to operate this equipment if an unauthorized
change or modification is made.
NOTE
This equipment has been tested and found to comply with the limits for s Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in a residential installation. This equipment may cause harmful
interference to radio communications, if it is not installed and used in accordance with the instructions. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined byturning the equipment off and on, the user is encouraged to try to correct the interference byoneormore of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
For the U.S.A.
-CAUTION:
Use of controls or adjustments or performance of
procedures other than those specified herein may result
in hazardous radiation exposure.
In compliance with Federal Regulations, following are
reproductions of labels on, or inside the product relating
to laser product safety.
The marking of products using lasers
(Except for some areas.)
CLASS 1
LASER PRODUCT
The label is attached to the rear panel and says that the component
uses laser beams that have been classified as Class 1.
It means that the unit is utilizing laser beams that are of a weaker
class. There is no danger of hazardous radiation outside the unit.
KENWOOD CORPORATION
2967-3, iSHIKAWA-CHO,
HACHIOJI-SHI,
TOKYO, JAPAN
KENWOOD CORP. CERTIFIES THIS EQUIPMENT
CONFORMS TO DHHS REGULATIONS NO, 21
CFR 1040.10, CHAPTER I, SUBCHAPTER J,
Location: Back Panel
16
DP-R895(Enf