Controlling; Mode Reset; X10 Modules; X10 Functions - X10 UR74A Owner's Manual

7 . 7 . 7 . 7 . 7 . Repeat steps 5 and 6 for each button you
want to learn.
8 . 8 . 8 . 8 . 8 . When you've
finished learning all
the keys, press
SETUP .
Notes:
Make sure you have fresh batteries in
both remotes before learning.
Take care not to move either remote
while pressing the buttons.
Experiment with the distance between the
remotes if you have a problem learning.
Some remotes do not have their LED in
the center so you might need to
experiment with the side-to-side position
of the remotes relative to each other.
Do not sit directly under an incandescent
lamp while teaching the Remote.
In most cases you hold the button on the
remote you are learning from until the
LED goes out on the Learning Remote. In
some cases however, you might find that
the LED on the Learning Remote doesn't
go out until you release the key on the
remote you are learning from.
You cannot store any functions under the
following keys:
earn, Setup, TV, VCR, Cable, SAT, X10.
L
You can store up to 50 buttons each for
three different remotes.
REST REST REST RESTORING THE DEF REST ORING THE DEFA A A A A UL ORING THE DEF ORING THE DEF ORING THE DEF UL UL ULTS UL
If you have problems learning keys, try a
Mode Reset or Master Reset, and then try
learning them again.

Mode reset

Mode reset
Mode reset Mode reset Mode reset
Press and hold Setup until LED lights,
then press Mode, Learn, Learn, Setup.
This restores the default code for that
particular Mode (TV, VCR, CBL, AUX).
Master reset Master reset
Master reset Master reset Master reset
Press and hold Setup until LED lights,
then press Learn, Learn, Setup. This
restores the default for ALL keys.
1 6 1 6
1 6 1 6 1 6
If you have purchased and installed a
Transceiver Module, you can control it
and other X10 modules as follows:
1 . 1 . 1 . 1 . 1 . Press and release the
X10 button.
2 . 2 . 2 . 2 . 2 . Use the number
buttons to enter the
Unit Code number of
the chosen module.
(You do not need to
enter '0' first for a
single digit number.)
3 . 3 . 3 . 3 . 3 . Press the appro-
priate button for the
function you require
(see below).

X10 FUNCTIONS:

On:
Off:
Bright:
Dim:
All Lamps On:
All Modules Off:
TS TS TS TS
Note: You cannot dim or brighten an
Appliance Module. If the module was off
and you press Bright or Dim (VOLUME+
or VOLUME-) this will simply turn the
module on.
C C C C C
ONTROLLING ONTROLLING ONTROLLING ONTROLLING ONTROLLING
X10 M X10 M
X10 M X10 M X10 M
ODULES ODULES ODULES ODULES ODULES
CHANNEL +
CHANNEL –
VOLUME +
VOLUME –
POWER
MUTE
1 7 1 7
1 7 1 7 1 7