Changing The X10 House Code; Controlling An Ir Mini Controller - X10 Wireless MouseRemote UR86A Owner's Manual

C X10 H
HANGING THE OUSE
The MouseRemote defaults to House
Code A, and in most cases you will not
need to change this unless you are
experiencing interference from a
neighboring X10 system.
1. Press and release the
X10 button.
2. Press and hold
SETUP until the
LED indicator lights
steadily. Release the
Setup button.
3. Use the number
buttons to enter the
number equivalent to
the chosen House
Code (1=A, 2=B
..16=P).
4. Press the ENTER
button to confirm the
House Code. The
LED turns off.
Note: The Housecode you choose must
match the Housecode on the Transceiver
Module you are using it with.
IMPORTANT: make sure above that you
press X10, Setup, then the number for the
Housecode you want, then Enter. If you
accidentally press Setup, X10, then a
number, you might change the code for
the X10 button, and it will no longer
work as an X10 button. You will then
need to change the X10 button back to
code 780 as described on the following
page.
28
C C
ODE ONTROLLING AN
IR M C
INI ONTROLLER
If you already own an IR Mini Controller,
you will need to change the X10 Home
Automation code in the remote to use it.
The code for standard X10 Home
Automation is 780. The code to control
the IR543 Mini Controller is 781. To
change the code:
1. Press and hold
SETUP until the
LED indicator lights
steadily. Release the
SETUP button.
2. Press and release the
X10 button.
3. Enter 781 to control
an IR Mini
Controller, 780 for
standard X10
control. The LED
turns off after the
last digit entered.
Note: In most cases, you will not need to
use an IR543 Mini Controller to receive
commands from the MouseRemote - the
Transceiver Module (or any X10 Security
System) does this for you and has the
added advantage of working through
walls. It also has the advantage of letting
you control up to 16 X10 Modules - i.e.
with a Transceiver when you press 1-6-
ON you turn on Module number 16. With
an IR543 when you press 1-6-ON you
turn on Modules 1 AND 6. The IR543 can
only control 10 Modules (1-9 plus
0=10). You cannot control the IR543
Mini Controller and the Transceiver
Module at the same time from the X10
button, but you can program an IR Mini
Controller under the AUX button.
(IR543)
29