Changing The Location Of The Pip Window; Freezing The Pip Display; Watching Multi-Window Pip - Toshiba COLORSTREAM 36A61 Owner's Manual

Changing the location of the PIP window
With the TV in PIP mode, press LOCATE to change the location of
the PIP window on-screen. Every time you press LOCATE, the PIP
window changes position counter-clockwise.
Freezing the PIP display
With the TV in PIP mode, press
STILL
to freeze the PIP display. The
PIP picture becomes still, and is outlined in red on-screen. Press
STILL again to restore the moving picture (outlined in green).
ADV/
PIP CH
REC TV/VCR REW FF
(®
TOSHIBA
CT-9946
SOURCE
- PIP
- SWAP
- LOCATE
STILL
ii i i ..
- Still
Watching multi-window PIP
Multi-window PIP appears as six small boxes across the bottom of the
screen. The multi-window PIP displays only the channels you
programmed into the TV's memory (see "Adding channels to the TV's
memory" on page 17).
Note: The LOCATE, SWAP, PIP CHANNEL AV, SOURCE,
and STILL
buttons do not function in multi-window PIP mode.
To view multi-window PIP:
Press PiP three times.
The TV cycles through all of the programmed channels, showing a
few seconds of each channel's programming, and then freezes the
image and moves on to the next channel in a continuous cycle. The
channel number appears above each PIP window.
Note:
Mu/tFwindow PIP displayschannels
programmed for the signal source you are
currently viewing (ANT-1 or Cable).
Note:
If V-Chip blocking is enabled when
you view multFwindow PIP, channels
exceeding the rating limits will appear
as a black window with a red "X."
To turn multi-window PIP offi
Press PiP again, or change the channel.
29