Changing The Location Of The Pip Window; Freezing The Pip Display; Watching Multi-Window Pip - Toshiba 36AF12 Owner's Manual

Changing the location of the PIP window

With the TV in PIP mode, press LOCATE to change the location of
the PIP window on-screen. Every time you press LOCATE, the PIP
window changes position counter-clockwise.

Freezing the PIP display

With the TV in PIP mode, press STILL to freeze the PIP display. The
PIP picture becomes still, and is outlined in red on-screen. Press
STILL again to restore the moving picture (outlined in green).

Watching multi-window PIP

The multi-window PIP feature provides a quick on-screen overview of
all channels programmed into the TV's memory (see "Programming
channels into the TV's memory" on page 17). The channels appear
continuouly in six small windows across the bottom of the screen.
Note: LOCATE, SWAP, PIP CHANNEL
STILL do not function in multi-window PIP mode.
To view multi-window PIP:
Press PIP a total of three times (the first press displays a 1/9-size
window; the second press displays a 1/16-size window; and the
third press displays multi-window PIP).
The TV cycles through all of the programmed channels, showing a
few seconds of each channel, and then freezes the image and moves on
to the next channel, in a continuous cycle. The channel number
appears above each PIP window.
14 23 27 30 43 56
X
To turn multi-window PIP off:
Press PIP again, or change the channel.
Still
, SOURCE, and
yz
Note:
If V-Chip blocking is enabled when
you view multi-window PIP, channels
exceeding the rating limits will appear
as a black window with a red "X. "
29
ADV/
PIP CH
FAV
ENTER FAV PIP CH
ADV/
PIP CH
SOURCE
STOP SOURCE PLAY PIP
PIP
REC TV/VCR REW FF
SWAP
STILL LOCATE SWAP
LOCATE
STILL
CT-9946
Note:
Multi-window PIP displays channels
programmed for the signal source you are
currently viewing (ANT-1 or Cable).