Table of Contents
Advertisement
2. Setting up the monitor
2.3 Remove the Base Assembly
for VESA Mounting
Remove the Base Stand
Before you start disassembling the
monitor base, please follow the
instructions below to avoid any possible
damage or injury.
1. Place the monitor face down on a
smooth surface, taking care to avoid
scratching or damaging the screen.
2. Use your fingers to loosen the screw
located at the bottom of the base,
and remove the base from the
stand.
3. Remove the hinge cover from
monitor body by using your fingers.
4. Use a screwdriver to remove the
screws on the arm, and then detach
the arm/stand from the monitor.
Note
This monitor accepts a 75mm x 75mm
VESA-Compliant mounting
interface. VESA Mounting Screw
M4. Always contact manufacturer
for wall-mount installation.
75mm
* Display design may differ from those
illustrated.
Warning
• To avoid potential screen damage,
such as panel peeling, ensure that
the monitor does not tilt downward
by more than -5 degrees.
• Do not press the screen while
adjusting the angle of the monitor.
Grasp only the bezel.
9
75mm
0°
90°
-5°
Advertisement
Table of Contents
