Nstalling The Omponents; Transceiver Module; Lamp Module; 6- In -1 Super Remote - X10 HK10A SUPERREMOTE Owner's Manual

I
NSTALLING THE
C
OMPONENTS
T M
RANSCEIVER
The Transceiver Module receives radio
frequency (RF) commands from remotes to
operate a lamp or appliance plugged into
it. The Transceiver Module also passes on
commands over your house wiring to
control other X-10 modules. Note that
unlike the Lamp Module you cannot dim
and brighten a lamp connected to the

Transceiver Module.

You should locate the Transceiver Module
centrally in the home for maximum range
when controlled by a remote.
1. Set the House
Code to 'A.'
2. Plug a lamp or
appliance into the
Transceiver
Module.
3. Plug the
Transceiver Module
into a convenient
AC outlet. Fully
extend the antenna.
L M
AMP ODULE
The Lamp Module may be used to control
any incandescent lamp rated up to
300W. It is not suitable for other types of
lamp such as fluorescent or energy saving
lamps, or lamps which include a dimmer
control.
Caution: Do not connect an appliance
such as a coffee pot or heater to the Lamp
Module. It may damage the module and
the appliance and could cause a fire
hazard.
ODULE
8
1. Set the House
Code to 'A' and the
Unit Code to '2.'
2. Plug a lamp into
the Lamp Module.
3. Plug the Lamp
Module into a
convenient AC
outlet.
6- -1 S R
IN UPER
The 6-in-1 SuperRemote allows you to
control practically everything electrical in
your home. It combines IR technology that
lets you control all your TV, VCR, Cable
and Satellite equipment with X-10 RF
technology that lets you control lamps and
appliances anywhere in your home.
To find out more about configuring the
SuperRemote to work with your audio/
video equipment, see the section titled
"Setting Up your SuperRemote."
1. Push the tab and lift
off the battery
cover.
2. Fit two AAA
batteries, taking
care to match the +
and - marks in the
battery
compartment.
EMOTE
9