Advertisement
2. Alignment and Adjustments
2-1 When Entering Service Mode:
2-1-1 Service Mode Entry Method
1. Turn off the power to make the SET STAND-BY mode.
2. In order to enter the Service Mode, Press "INFO" → "MENU" → "MUTE" → "POWER" button on the Remote
Control.
In case entry into SERVICE MODE is unsuccessful, repeat the procedures above.
2-1-2 Initial DISPLAY State in times of SERVICE MODE Switch overs
2-1-2(A) OSD DISPLAY
Factory
1. ASI510 (MAIN)
2. ASI510 (SUB)
3. VPC3230 (MAIN)
4. VPC3230 (SUB)
5. FLI2310
6. MTS9883
7. DNIe
8. CCA
9. SP ACTUATOR
2-1-2(B) BUTTONS OPERATIONS WITHIN SERVICE MODE
MENU
Direction keys ▲ / ▼
Direction keys ◀ / ▶
Source
Samsung Electronics
10. DDP1011
11. LNA PLUS
12. DDP PATTERNS
13. ASI PATTERNS
14. OPTION TABLE
15. CHECK SUM
16. RESET
Full Menu Display / Move to Parent Menu
Item Selection by Moving the Cursor
Data Increase/Decrease for the Selected Item
Cycles through the active input source that are connected to the unit
Alignment and Adjustments
2-1
Advertisement
