Sealey LED016 Manual

thank you for purchasing a Sealey product. manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
instructions
1. SAfety
1.1. geneRAl
DO nOt shine directly into your, another person's or an animal's eyes.
8
DO nOt allow children to use the torch.
8
DO nOt use the torch if you suspect that the battery or the torch casing is damaged.
8
DO nOt leave batteries in a discharged state. Before storage remove batteries.
8
1.2. BAtteRy SAfety
WARning! To reduce the risk of burns or fire:
‰
DO nOt attempt to open the batteries.
8
DO nOt crush, puncture, short contacts or dispose of in fire or water.
8
DO nOt expose to temperatures above 60°C (140°F).
8
Replace only with the batteries designed for this product.
9
Recycle or dispose of used batteries as stipulated by local regulation.
9
If the electrolyte in the batteries gets on your skin, rinse thoroughly with water. If it gets in your eyes, rinse thoroughly with
9
cool water and seek immediate medical attention.
2. intRODuCtiOn
Powerful, precise and pocket-sized penlight. 1W CoB gives extremely bright light with up to 50 lumen output. CRee XTe side light with up to
55 lumen output. On/off fingertip switch. Powered by 1 x AAA batteries (not included).
3. SPeCifiCAtiOn
Model no: ................................................................. led016
Battery: .............................................. 1 x AAA (Not included)
led Qty: ............................................ CRee XTe + 1W CoB
length: ....................................................................... 142mm
lumen output: .................................XTe - 55lm, CoB - 50lm
nett Weight: ..................................................................... 26g
operating Time: .............................................................. 3hrs
4. OPeRAtiOn
4.1. Unscrew the end of the pen.
4.2. Place one 1.5V AAA battery into the pen observing the "+" "-" polarity.
4.3. Replace the barrel of the pen light.
4.4. The light sequence is as follows: Firstly press the top button to turn XPE LED on, press again to turn XPE LED off, press to turn COB
on, then press to turn COB off (fig.1).
5. mAintenAnCe
5.1. Keep the torch clean by wiping with a damp cloth.
5.2. Remove batteries if not being used for a long period of time.
5.3. Store torch and batteries in a dry childproof area.
XTE LED
fig.1
© Jack Sealey limited
Aluminium Penlight CRee Xte + 1W COB
leD016
Model no:
COB LED
Original Language Version
On/Off
led016 Issue 1 28/01/19