Table of Contents
Advertisement
Set it up
1
Place the bracket against the wall
using a level to make sure it's aligned,
and mark the screw holes. Remove
the bracket.
2
If you're using wall anchors, use a
5/16" drill bit to drill 2 pilot holes,
starting with the hole on the top. Then
insert the wall anchors. (Don't use
wall anchors if you're drilling into
wood or plastic.)
If you're not using wall anchors,
locate a wall stud and drill the pilot
holes with a 9/64" bit.
3
Place the bracket against the wall
with the arrows facing up. Secure it
using 2 long wall bracket screws
(included) and a power drill or
Phillips-head screwdriver. Drive the
top screw in halfway. Drive the bottom
one in all the way, then tighten the top
screw.
Advertisement
Table of Contents
