Advertisement
4.4 WIRE CONTROL MODE
1) Connect wire controller to connector, it is located on the backside of the machine.
Whilst connect machine the Red LED (POWER) on the control box will illuminate.
2) Turn the key switch(SNOW ON/OFF) on the control box to ON, the Green
LED (IN USE) on the control box will be illuminate, the unit is ready to working. The
LED display will show "oUt".
3) Adjust the potentiometer knob(OUTPUT VOLUME) on the control box to control the
volume of the snowflake.
4) Turn the switch (AIR VOLUME SWITCH) located on the backside of the machine,
to adjust the rev of the air pump. min.and max.rev (MIN,MAX) available.
5) Turn the key switch(SNOW ON/OFF) on the control box to OFF, the unit will stop
output.
4.5 REMOTE CONTROL MODE
1) Connect remote controller receiver to connector, it is located on the backside of
the machine.
2) Press the lock button of "
" on the remote for operation, the machine will auto
output. And LED display shows
And then use the "
"and "
" buttons to choose the output snowflake volume
from "P1"to "P10", then press the "ENTER" button to confirm.
Press"
"button
3) Turn the switch (AIR VOLUME SWITCH) located on the backside of the machine,
to adjust the rev of the air pump. min.and max.rev(MIN,MAX) available.
4) Press the lock button of "
" on the remote for operation, the machine stop
output.
.
ENTER
Output Snowflake
to
confirm
volume
4.6 DMX MODE
1) Operating in a DMX control mode environment gives the user the greatest flexibility
when it comes to customising or creating a show. In this mode you will be able to
control each individual trait of the fixture and each fixture independently.
2) DMX address setting:
Press the "FUNC" button on the unit to show
"ENTER" button then use the "
address, then press the "ENTER" button to confirm.
Press"FUNC" button
Set DMX address
Note: This unit is designed so the DMX control takes priority. When a DMX controller is
connected the machine, the wire control function and the wireless remote control
function will both be disabled.
3) Connect DMX controller to operation.
4) DMX function
Channel
Value
CH1
0-255
4.7 Set LED display panel indicator function:
Press the "FUNC" button on the unit to show
"ENTER" button then use the "
indicator ON or OFF, then press the "ENTER" button to confirm.
NOTE:
Once confirm to "on", the LED display will always on bright.
Once confirm to "oFF", the LED display will close after 15 seconds. But will activation
after press any buttons on display panel.
Press "FUNC" button
8
on the LED display. Press the
"and "
" buttons to choose the required DMX
ENTER
ENTER
confirm
to
confirm
Function
Snowflake from 0% to 100%
on the LED display. Press the
"and "
" buttons to choose the display panel
ENTER
confirm
ENTER
The LED display panel
always
confirm
on bright.
The
ENTER
LED display panel
confirm
will closed after 15 seconds.
Enter
DMX address
9
Advertisement
