Advertisement
3. Installation
3.1 Set-Up:
Installation of the device must be handled by a familiar with the
hazards and the relevant regulations qualified persons.
Only authorised persons may carry out work with the machine.
Do not use the machine if there are people or animals in the direct output
Make sure there are no objects in the direct output that can be damaged by the
machine. (e.g. by getting wet).
Make sure that children unauthorised people can animals do not obtain access to the
machine.
Do not connect more units to a single electrical circuit than the installed fuse is able to
handle.
Do not remove any safeguards, safety caps and safety symbols.
All required safety devices must be in good condition and function properly.
Ensure sufficient lighting of the surroundings.
Keep the workplace clean.
3.2 The machine must be used in surroundings that:
Have a stable temperature of between 0
Have a relative humidity degree between 20% to 90% (non condensing)
Are free of dust, corrosive gases and high concentrations of organic vapours.
Are not situated in the vicinity of a source of vibration.
3.3 The machine is designed for indoor and outdoor use.( The machine is designed for
outdoor use and use in well-ventilated indoor spaces.)
WARNING
The machine can not be used in rain or other wet conditions.
Always create a safety zone of 3 m in front of the machine when the snow comes
direct from the snow output.
CAUTION
Walk carefully when approaching the machine. The floor can be slippery due to
spilled snow liquids.
to 50 .
℃
℃
3.4 INSTALL THE MACHINE
Install the machine on a firm surface with the supplied bracket the machine can be
placed under an angle.
Mount the bracket using the supplied bolts and spacers.
Place the machine under and angle by rotating the bracket to the bottom side of the
machine and tighten the knobs on the both sides.
4. Operation instructions
4.1 CONNECT POWER
1) Make sure that the power switch is off.
2) Connect a power cable to the Power input.
3) Connect the other end of the cable to the Power supply.
CAUTION: Do not connect more units to a single electrical circuit that the installed fuse
is able to handle.
4.2 PLACE THE BOTTLE WITH SNOW LIQUID.
1) Always follow the instructions as noted on the snow liquid bottle.
2) Place a bottle with snow liquid in the machine and remove the original lid.
3) Connect the snow lid with hose on the bottle.
4.3 POWER ON.
1) Make sure that the direct output is free from persons and objects.
2) When it's time to snow, switch the power on.
3) LED Display panel, it is located on the backside of the snow machine.
It will displays
.
4) To select control mode to operation machine to output snowflake.
WARNING
To achieve the maximum service life of the blower you must be must be stop 10
minutes after running 20 minutes.
6
7
Advertisement
