Wolf WWD30 Installation Instructions Manual page 9

I N S TA L L AT I O N I N S T R U C T I O N S
I N T E G R AT E D D R A W E R F R O N T
O V E R L AY A P P L I C A T I O N
A minimum 33" (838) wide by 24" (610) deep
cabinet is required for the warming drawer
with integrated drawer front using the overlay
application. A minimum base support of 200
lbs (91 kg) is required. Refer to the illustration
on page 8.
I N S E T A P P L I C AT I O N
IMPORTANT NOTE: The inset application
requires the warming drawer to be recessed
into the cabinet. A minimum 25" (635) deep
cabinet is needed if you want the front panel
to be flush with surrounding cabinetry.
If you are installing the warming drawer with
integrated drawer front in an inset application,
a minimum 33" (838) wide and 25" (635) deep
cabinet is required for this installation. A
minimum base support of 200 lbs (91 kg) is
required. Refer to the illustration below.
2" 2"
(51) x (51) DIMENSION
ANTI-TIP BLOCK WILL VARY*
1
10 / "
4
(260)
7
9 / "
8 (251)
OPENING
HEIGHT
36"
STANDARD
24"
(610) + THICKNESS
FLOOR TO
OF DRAWER FACE
COUNTER
FOR OPENING DEPTH
25"
min (635)
CABINET DEPTH
*Allow enough room for placement of anti-tip block.
Integrated Drawer Front – Inset Application
Dimensions in parentheses are in
millimeters unless otherwise specified.
U N D E R C O U N T E R I N S TA L L A T I O N
For undercounter installations, 23
from the bottom of the warming drawer
opening to the floor is recommended. It must
be installed a minimum of 5" (127) above the
floor or 1" (25) above the toe kick.
The Wolf warming drawer with integrated
drawer front may be installed below a 30"
(762) or 36" (914) wide electric or gas cooktop,
provided the warming drawer is fully enclosed,
top and bottom. Refer to installation instruc-
tions for the cooktop for additional specifica-
tions. Dimensions will vary according to the
specific installation.
MINIMUM CABINET WIDTH
(914)
HEIGHT
33"
(838)
5"
E
(127)
4"
(102)
1
29 / "
2 (749)
5"
OPENING WIDTH min (127)
BOTTOM
OF OPENING
TO FLOOR
1
/ " (597)
2
9