Philips HD7888 Manual page 30

English
30
The filter overflows when I
remove the jug from the
coffee machine while it is
brewing coffee.
The coffee machine
continues to drip long after
the brewing process has
ended.
Can't wait for the last few
drops.
The coffee is not hot
enough.
The coffee beans seem to
be used up quickly.
The timer does not work.
Error code
Error code Descrip­
tion
E1 Water
shortage
E2 Bean
container
unavailable
Use ground coffee of a stronger blend or flavor.
If you remove the jug for more than 20 seconds during the brewing process,
the drip stop causes the filter basket to overflow. Also note that the coffee
does not reach its full taste before the end of the brewing process. Therefore
we advise you not to remove the jug and pour out the coffee before the end
of the brewing process.
The dripping is caused by condensation of steam. It is completely normal that
the coffee machine drips for some time.
Switch the knob from cup to jug mode to open the drip stop function, drip
stop will stop the dripping from the filter basket.
If the dripping does not stop, the drip stop may be clogged. To clean the drip
stop, open the filter basket holder and take out the filter basket. Rinse the
filter basket and the drip stop under the tap.
The coffee in the jug cools down faster if you brew only a few cups. The
coffee stays hot longer if you brew 10 cups, which is a full jug.
Descale the coffee machine.
To brew a perfect cup of coffee, the coffee machine needs a certain amount
of ground coffee. The amount of coffee beans the coffee machine uses to
obtain the optimal amount of ground coffee per cup is normal.
Make sure you complete all steps for brewing coffee with coffee beans or
pre-ground coffee before you set the timer.
Solution
Press any button to put the appliance
on standby mode.
Refill the water tank and restart the
appliance.
Press any button to put the appliance
on standby mode.
Attach bean container securely and
restart the appliance
Remark
If this problem persists, follow these
steps:
Press and hold the cleaning and start
button simultaneously for three
seconds, until the appliance
automatically starts pumping water
for one minute. Repeat this process 3
times.
Contact customer service if the
problem still persists.
Contact customer service if the
problem persists.