Table of Contents
Advertisement
Pixel Shift
• The images will be automatically shifted by one pixel
every 80 seconds to prevent image sticking.
• You can change the pixel shifting setting using the
OLED Pixel Shift option in the Settings>Device
Preferences>Picture>OLED menu. On and Off
options will be available.
• The image on the screen will be shifted horizontally
and vertically, following a rectangular-shaped orbit.
Other Precautions
There are also some other precautionary
measures to prevent image sticking.
• A screen saver feature is embedded to prolong
the display panel's lifetime. The screen saver
will be activated after the defined time in the
Settings>Device Preferences>Screen Saver
menu expires. In Live TV mode, it will be activated
automatically (after a period of approximately five
minutes of inactivity) regardless of the configuration
in the Screen Saver menu if the TV detects that a
static image is displayed on the screen. Press any
button on the remote to exit screensaver mode.
Antenna Connection
Connect the aerial or cable TV plug to the AERIAL
INPUT (ANT) socket located on the left side of the TV
or satellite plug to the SATELLITE INPUT (LNB) socket
located on the rear side of the TV.
Left side of the TV
ANT
Rear side of the TV
LNB
If you want to connect a device to the TV, make
sure that both the TV and the device are turned off
before making any connection. After the connection
is done, you can turn on the units and use them.
Turning On/Off the TV
Connect power
IMPORTANT: The TV set is designed to operate on
220-240V AC, 50 Hz socket.
After unpacking, allow the TV set to reach the ambient
room temperature before you connect the set to the
mains.
Plug one end (the two-hole plug) of the supplied
detachable power cord into the power cord inlet on
the rear side of the TV as shown above. Then plug
the other end of the power cord into the mains socket
outlet. The TV will switch on automatically.
Note: The position of the power cord inlet may differ depending
on the model.
To switch on the TV from standby
If the TV is in standby mode the standby LED lights
up. To switch on the TV from standby mode either:
• Press the Standby button on the remote control.
• Press the centre of the joystick on the TV in.
To switch the TV into standby
The TV cannot be switched into standby mode via
joystick. Press and hold the Standby button on the
remote control. Power off dialogue will appear on the
screen. Highlight OK and press the OK button. The
TV will switch into standby mode.
To switch off the TV
To power down the TV completely, unplug the power
cord from the mains socket.
Quick standby mode
In order to switch the TV into quick standby mode
either;
• Press the Standby button on the remote.
Press again to go back to operating mode.
• Press and hold the centre of the joystick on the TV.
Press again to go back to operating mode.
Your TV continues to operate in the quick standby
mode state, as it regularly checks for updates. This is
not a malfunction, it meets the requirements for energy
consumption. In order to minimise energy consumption
switch your TV into standby mode as explained above.
Note: When the TV is switched into standby mode, the standby
LED can blink to indicate that features such as standby search
or timer is active. The LED can also blink when you switch on
the TV from standby mode.
English - 8 -
Advertisement
Table of Contents
