Danger! 5. Spindle lock When using the equipment, a few safety pre- 6. Clamp nut cautions must be observed to avoid injuries and 7. Handles damage. Please read the complete operating 8. Fastening screw for depth adjuster instructions and safety regulations with due care. 9.
• Open-ended wrench (2x) Total vibration values (vector sum of three direc- • Copy sleeve tions) determined in accordance with EN 62841. • Safety guard • Original operating instructions Handle • Safety instructions Vibration emission value a = 0.813 m/s K uncertainty = 1.5 m/s The stated vibration emission levels and stated 3.
5. Before starting the equipment the front section of the parallel stop (19). • Screw-fit the compass point (18) on the par- allel stop (19) as shown in Fig. 5. Now fit the Warning! parallel stop (19) together with the compass Always pull out the battery before making ad- point (18) on the router.
6. Operation respective insert as described in section 5.5 • Cutters with a shaft diameter of 6 mm and 8 • mm can be used in the cordless palm router. Never use a low-quality or damaged cutter. Most cutters are available in both sizes. Use only cutting tools with a shaft diameter of •...
Page 20
workpiece. edge of the workpiece. • • Hold the router’s handle. Perform the cut as explained in section 6.3. • Place the cordless palm router on the workpi- ece. 6.6 Making cuts freehand • Set the routing depth as explained in section The cordless palm router can also be used wit- 5.5.
7. Cleaning, maintenance and If the battery pack fails to become charged, ple- ase check ordering of spare parts • whether there is voltage at the socket-outlet • whether there is proper contact at the char- Hazard! ging contacts on the charger. Always pull out the battery pack before starting any cleaning work.
Page 22
The reprinting or reproduction by any other me- ans, in whole or in part, of documentation and papers accompanying products is permitted only with the express consent of the Einhell Germany Subject to technical changes - 22 - Anl_TP_ET_18_Li_BL_SPK7_THA.indb 22 Anl_TP_ET_18_Li_BL_SPK7_THA.indb 22...
10. Charger indicator Indicator status Explanations and actions Red LED Green LED Off Flashing Ready for use The charger is connected to the mains and is ready for use; there is no battery pack in the charger Off Charging The charger is charging the battery pack in quick charge mode. The char- ging times are shown directly on the charger.
* Not necessarily included in the scope of delivery! Please register the product warranty of Einhell brand products. Customers must scan the QR Code of the Serial number in the product or QR code on the box, to additional 6 months warranty for the whole battery and battery charger (Note: Promotion is change without prior notice.
Need help?
Do you have a question about the TP-ET 18 Li BL and is the answer not in the manual?
Questions and answers