Kenwood KT-990D Instruction Manual page 20

Operating instructions
@ Auto tuning reception
1) Set the input selector of the amplifier to TUNER.
(2) Press the POWER switch.
The FREQUENCY DISPLAY lights and the frequency of the
last station* is displayed.
@) To listen to AM stations, press the AM SELECTOR switch.
The frequency display shows the last AM station.
To listen to FM stations, press the FM SELECTOR switch.
The frequency display shows the last FM station.
(@ Set the TUNING MODE switch so that the AUTO indicator
lights.
(5) To tune in the higher frequency station, turn the TUNING
knob slightly clockwise. To tune in the lower frequency
station, turn the TUNING knob slightly counterclockwise.
KENWOOD auartz SYNTHESIZER AM-FM STEREO TUNER KT-990D
C1304
1H
ACTIVE RE FM A , AUTO ST.
@PROGRAM REED On > /SELERTOR ic Elko REC CAL SENS. LEVEL UTO $
@ Manual tuning
Use manual tuning mode to receive a weak signal station.
Perform procedures 1, 2 and 3 above.
(2) Set the TUNING MODE switch so that the MANUAL TUN-
ING indicator lights.
(8) Turn the TUNING knob while obsérving the frequency
display to tune in the desired station.
4) Adjust the volume and tone of your amplifier.
KENWOOD auartz SYNTHESIZER AM-FM STEREO TUNER KT-990D
POWER
@PROGRAM RECEPTION SELECTOR i.
M@ Preset tuning
() Receive a station.
@Q) Press the MEMORY switch. (Press for more than 1 se-
cond.) The MEMORY indicator lights for about 5 seconds.
(3) While the MEMORY indicator lits, press one of the preset
station switches.
The MEMORY indicator goes off and the station being
KENWOOD quartz SYNTHESIZER AM-FM STEREO TUNER KT-990D
POWER
=
a ON 2D OFF
CS (EE een yre er mes
coo Ooo oO
@ PROGRAM RECEPTION SELECTOR EM REC CAL SENS. LEVEL AUTO, ST
8 KT-990D (k)
The stations are automatically scanned. The TUNING
SIGNAL indicators illuminate according to the signal
strength and the tuned station can be heard.
(6) Adjust the volume and tone of your amplifier.
*Last station :
As the memory of this unit is backed up, the frequency
received before the power is turned off is memorized.
This is referred to as the last station frequency. When the
power is turned on again, the unit tunes in the last station
frequency.
TUNING
pimect wear oor vetecton =OLLD oo
(LE ED
© MANU
Note:
In FM broadcast reception by manual tuning in Continental Europe,
Great Britain and other areas, the received frequencies are different
from the frequencies displayed on the frequency display when the
last digit of display is 2 or 7, as shown in the table below. This is due
to the frequency steps used in those areas, and there is no problemin
reception.
Last Displayed Digit Actual Recieved Frequency
25 kHz
75 kHz
O (same as displayed)
TUNING
owect uncar coop cetectorn «DLL "o
EAU ANE Att PU e e
received is stored in the pressed preset station switch.
Perform the same procedures on other preset staton
switch.
To receive the preset station, press the correspondng
preset station switch.
TUNING
Owect unean oop oerecton §=DLLD ae
LATE LAH
TUNING MODE