Pioneer KEH-3200QRUC Service Manual page 4

2. USING THE RADIO
@ KEH-32000R, KEH-22000R, KEH-3250QR, KEH-22500R
Pop-up button Preset
KEH-32000R
Fader Bass Treble Display
Preset scan Best stations memory
Local station
Volume/balance/loudness/
power switch (KEH-32000R, KEH-22000R, KEH-32500R)
Volume /balance power switch (KEH-2250Q0R)
Loudness (KEH-3200QR, KEH-22000R, KEH-32500R)
Seek Frequency
Fi toc SEEK
Band Preset number
Stereo
@ KEH-1250
Band Tuning Preset
@ PIONEER
CARBETTE RECEIVER
Balance Tone
Best stations memory
Local station
Volume/power switch
Preset scan
a
Seek * Frequency
Local
Stereo
Band Preset number
®@ Before attempting operation...
@ Set the fader control to the upright position.
1. Turning the power switch to the right causes power to switch ON
and the current frequency to appear on the display.
@ Since the set is designed preferentially for tape play, eject a
cassette tape, if mounted, before operating the radio.
2. Press the band switch to select the band.
3. Press both ends of tuning button and the seek tuning indicator
will appear on the display.
4. Press either the left or right side of the tuning button to tune in
the desired frequency. (Pressing the right side will increase the
frequency.)
5. Adjust the volume and balance. To adjust the balance, first pull
the knob until a click is heard. After setting to the desired level,
push the knob in again to its original position.
6. Adjust the tone.
@ To enter a frequency into the preset memory...
7. Hold down one of the preset buttons (1-6) for approximately two
seconds. The frequency is stored in memory (assigned to the
preset button pressed) once the preset number stops flashing on
the display.
Six FM1 frequencies, six FM2 frequencies, six FM3 frequencies
and six AM frequencies can be entered.
@ Best Stations Memory Button
Automatically tunes strong frequencies and assigns them to preset
buttons 1 through 6 for one-touch automatic tuning. The best sta-
tions memory function is activated by pressing this button for ap-
proximately 2 seconds. The best stations memory function is indi-
cated by ——— flashing on the display, and this function can be
canceled by pressing the band switch. The frequency display re-
turns once the best stations memory function is complete. The fre-
quency displayed at this time is of the strongest station assigned to
preset button 1 by the best stations memory function.
© 6 best (strongest) frequencies are memorized in the 6 preset but-
tons in the order of their strength, the strongest one being as-
signed to preset button 1.
@ The frequencies previously assigned to the preset buttons are re-
tained when 6 frequencies cannot be located.
@ The best stations memory is in operation while ——— is flashing
on the display.
© Local Station Switch
Pressing this switch increases the seek threshold level so that only
relatively strong stations can be tuned in (local indicator will illumi-
nate on the display). Local seek threshold level can be selected
among four levels for FM and two levels for AM.
Holding this switch down for approximately 2 seconds and then
pressing the right side of the tuning button changes the display
from L-1, L-2, L-3 to L-4. Pressing the left side of the tuning button
changes the display from L-4, L-3, L-2 to L-1 (L-1 and L-2 for AM).
The bigger the number, the higher the seek threshold becomes and
only relatively strong stations can be tuned in.