Table of Contents
Advertisement
4.3. Starting the Unit in Road Mode
1. Start the vehicle engine.
2. Press the ON key (1) to start the unit.
Start-up time is delayed for 40 seconds. Compartment temperature
is then displayed.
3. Press the SET key (2) to check if the setpoint matches your need
and adjust it if needed.
Refer to Section 4.6, "Adjust the setpoint temperature" to get
the procedure.
4.4. Starting the Unit in Standby Mode (Option)
4.4.1. Introduction
For safe & reliable operation in Standby mode, it is important to
consider the following guidelines:
A. ALWAYS check that the unit is OFF from the cab command before
connecting or disconnecting it from the power source.
B. The unit connection cable must be fitted with a ground connection.
The cable must be connected to earth.
C. On the 400 V supply, the unit MUST BE CONNECTED to a high
sensibility (30 mA) differential protection.
D. Operations on the 400 V supply for the unit must only be carried out
by authorized personnel.
E. The user is liable for ensuring that the above measures are taken.
4.4.2. Standby Guideline Chart
Operating voltage
230V/1/50Hz
230V/1/60Hz
Standardized exten-
Max.
sion cable H.07.RNF
current
Maximum 30m
8.5 A
1,5 mm²
6.8 A
1,5 mm²
4.4.3. Prrocedure
Before Starting
• On the power network, check that the type of current
corresponds to the characteristics of the unit, see Section
4.4.2, "Standby guideline chart".
• On the unit: check if the power network is properly connected.
1.
Press the ON key (1) to start the unit.
Start-up time is delayed for 10 seconds. Compartment temperature
is then displayed.
Press the SET key (2) to check if the setpoint matches your need
2.
and adjust it if needed.
Refer to Section 4.6, "Adjust the setpoint temperature" to get
the procedure.
In the event of difficulty on start-up, check that:
• Network supply is ok.
• The temperature set on the cab command has not been
affected.
4.5. Stopping the Unit
• For a short stop (ex. delivery): simply switch OFF the vehicle
ignition.
• For a long stop: follow the instructions below.
1. Press the OFF key (1) to stop the unit.
4
62-12263
Advertisement
Table of Contents
