1. Introduction 3. Safety This guide has been prepared for the operator of Carrier Transicold re- 3.1. Warning and Precaution frigeration units. It contains basic instructions for the daily operation of the refrigeration unit as well as safety information, troubleshooting tips...
5. Place a warning pictogram by applying it on a dry surface. Press to external sides to eliminate air bubbles. 4.2.2. Standby Mode (Optional) NEOS 200e units are powered by a standby module reducing the 230 3.4. Recommendations VAC into 12 VDC.
4.4.3. Prrocedure 4.3. Starting the Unit in Road Mode Before Starting • On the power network, check that the type of current corresponds to the characteristics of the unit, see Section 4.4.2, “Standby guideline chart”. • On the unit: check if the power network is properly connected. 1.
4.6. Adjusting Setpoint Temperature Available Description parameter When adjusting, if no key is pressed within five seconds the Inhibit defrost function system returns to compartment temperature display. All changes are saved. Microprocessor-optimized automatic defrost Aut (coef- according to type of cargo transported (variable ficient 1) interval 0H / 1H /...
Wrong function setting / Loss of data - Micro AXX: current malfunctions not starting up / Stays in BOOT (Init phase) PXX: past malfunctions Maintenance needed. SE alarm will be displayed every 1000 hours alternatively with compartment T° and can be canceled by Carrier Transicold Service Center. 62-12263...
Confirmation of such operations can be detailed on request. 7.2. During Loading All maintenance services must be done by a technician trained on Carrier products respecting all safety and quality standards of • Stop the unit (place START/RUN/OFF switch in the OFF Carrier.
9. Emergency Road Service At Carrier Transicold, we are working hard to give you complete service when and where you need it. That means a worldwide network of dealers that offer 24-hour emergency service. These...
Need help?
Do you have a question about the NEOS 200e and is the answer not in the manual?
Questions and answers