Sony DTC-87ES Operating Instructions Manual page 6

| MoYer-1e(olam-lacem a llaveitteyameymO@xe)aline) [sy
Front Panel/Remote Commander
POWER switch
Turns the power on and off.
[2] Cassette compartment
Insert a cassette with the window side up and the safety
tab facing you.
(3) Display window
[4] 1D indicators
Display which ID button is pressed.
[5] REC MODE selector
Normally set to STANDARD.
When this selector is set to LONG, you can record analog
input signals or digital signals with 32 kHz in the long-play
mode,
[6] REC MONITOR switch and indicators
Switch the output signals from the LINE OUT jack, DIGITAL
OUT jack and PHONES jack during recording.
In the SOURCE mode, the signal being input is output.
In the TAPE mode, the signal to be recorded is output.
Music select buttons
Numeric buttons (0-9): Designate the desired program
number to be played back before starting playback.
CLEAR: Use to cancel the program number which has
been mistakenly entered.
MUSIC SCAN: Use this feature to listen to the beginning
of each selection successively.
DISPLAY MODE button
Change the display mode. (Refer to page 10.)
[9] REPEAT button
Press to play a desired portion repeatedly. Each time you
press the button, the indication changes as follows:
REPEAT 1 — REPEAT ALL -* Nothing
Remote sensor
Receives the signal from the Remote Commander.
INPUT selector
Set according to the signal to be recorded.
ANALOG: For recording from the equipment connected
to the LINE IN jacks.
OPTICAL: For recording from the equipment connected
to the DIGITAL IN (OPTICAL) jack.
COAXIAL: For recording from the equipment connected
to the DIGITAL IN (COAXIAL) jack.
TIMER switch
Normally set to OFF. Use start recording or playback at the
desired time using a commercially available audio timer.
OPEN/CLOSE button
Press when inserting or removing the cassette.