3.3
Flash Image to Board
Use the following steps to flash the OS to the BOXER-8622AI.
1)
Open terminal on the Ubuntu Host PC, then access the folder you extracted in
the previous section.
2)
Enter the following command in terminal to flash the image:
$ ./flashboxer.sh -s 62517420 nvme
3)
Wait as the image is installed. Once complete you should see the following:
4)
After Steps 2 and 3, mass-flash image is built up internally, so you can flash up to
10 targets at once by using the following command:
$ ./flashboxer.sh -m nvme
Chapter 3 – BSP Flash Guide
34