TP-Link TL-WPA8631P Quick Installation Manual

Quick Installation Guide
TL-WPA8631P
* TL-WPA8631P (European version) is used for demonstration in this guide.
* Images may differ from actual products.
e
r l i n
w e
P o
New Extender
TL-WPA8631P
1
Plug in the new extender near one of your existing powerline devices.
2
Check the new extender's Powerline LED
> Step 4
> Step 3
Existing Powerline Device
(for demonstration only)
. Is it on?
3
Pair the powerline devices.
A Press the Pair button on the existing powerline
device for 1 second. The Power LED starts blinking.
Note: If the Power LED does not blink, press the Pair
button again.
Blinking
Within 2 minutes
Existing Powerline Device
4
Relocate the extender to the Wi-Fi "dead" zone.
Connect your devices to the internet using the
default SSIDs (network name) and password
the label at the side of the extender
If you cannot find the SSIDs in your Wi-Fi network list, your new extender has automatically
copied over the existing wireless settings. In this case, use the SSID and password of your
existing powerline network to connect.
If you want to unify your Wi-Fi networks, refer to the back page for instructions.
Attention
1. Use the product only in the upright direction.
2. Plug powerline devices into wall outlets instead of power strips.
Using a power strip will affect network performance and may even cause dropped connections.
Wall Outlet Power Strip
B Within 2 minutes, press the Pair button on the new
extender for 1 second. The Power LED starts blinking.
When the Powerline LED on the new extender turns
on, the pairing process is complete.
Note: If the powerline LED is off, try another wall socket
or pair again.
Blinking
On
New Extender TL-WPA8631P
on
SSID:TP-Link_XXXX
SSID:TP-Link_XXXX_5G
.
Wireless Password:XXXXXXXX