Alpine ELITE CALGARY Owner's Manual page 41

Removing the Jets
You will need to remove the jet pieces to clean behind them (It's easier to remove
a jet piece when the spa pool is empty, however it is possible to do when filled).
Ensure the jet pump is off before attempting to remove any jets.
1
Grip the jet piece tight and turn in
an anti-clockwise direction.
To replace the jet piece, reverse the steps above and turn in a clock-wise direction.
Note: The HydroWave jet is not designed to be removed.
Interchanging the Jets
Jets of the same size mold can be swapped around to build custom seats. Choose
the desired jet pieces to interchange and follow the removal and replacement
steps above.
Jet pieces of the same size can be interchanged
ICE BUCKET
To use the ice bucket, simply fill the bucket with ice and
place in your favourite beverage to keep it cool. Melting
will occur, which will be drained from the cavity slowly
by a small drain hole at the bottom of the bucket, to the
bottom of your spa and onto your concrete. Keep this in
mind as not to mistake for a leak.
If the ice bucket fails to drain, remove the side panels and inspect the drain
hose for a kink or a blockage. (The securing screw will not block the water)
2
When you feel the natural
stopping point, apply slightly more
turning pressure while gently
pulling towards you.
3
The jet piece should pop out and
be able to be removed, exposing
the jet body.
41
41