Craftsman CMXGTAMD25CC Operator's Manual page 15

TIPS FOR BEST RESULTS
• For most operations, cut from side to side.
• MODEL NO. CMXGTAMD25CC: To direct clippings away from
the operator, tilt the cutting head slightly down to the left; cut
from right to left whenever possible.
• MODEL NO. CMXGTAMD25SC: To direct clippings away from
the operator, tilt the cutting head slightly down to the right; cut
from left to right whenever possible.
• Cut tall grass (over 8 inches (20cm)) from the top down by
lowering the cutting head onto the grass.
• Cut with the tip of the trimming line.
• Cut in small increments. Move slowly. Do not force the unit.
• Do not trim wet grass or weeds.
NOTE: Some line breakage will occur from:
• Entanglement with foreign matter
• Normal line fatigue
• Attempting to cut thick vegetation
• Forcing the line into objects such as walls or fence posts
DECORATIVE TRIMMING
When trimming around trees, posts, fences, etc., rotate the whole
unit so that the cutting head is at a 30° angle to the ground (Fig. 15).
15
Fig. 15