Advertisement
Quick Links
MS-700 OPTIMUM
QUICK START GUIDE
Power/Status
Line Output
Indicator LEDs
IP Address
Line Input
LCD Screen
AMPLIFIER
Line Input
Remote Control Ports
Speaker
PA
WPA-70x Input/Output XD Link Reboot/Factory Default
Connections
Mute
USB Port
PoE+ Network
Port
Link Button
Link Light
Microphone 2 Status
System Power Status
Microphone 1 Status
Advertisement
Related Manuals for Audio enhancement MS-700
Summary of Contents for Audio enhancement MS-700
- Page 1 MS-700 OPTIMUM AMPLIFIER QUICK START GUIDE Power/Status Line Output Line Input USB Port Remote Control Ports PoE+ Network Indicator LEDs Port IP Address Line Input Speaker WPA-70x Input/Output XD Link Reboot/Factory Default LCD Screen Connections Mute Link Button Link Light...
-
Page 2: Functional Summary
DESCRIPTION MS-700 Optimum Amplifier is a fully integrated networked classroom amplifier and wireless microphone receiver. This amplifier has network-based intercom, paging and emergency notifications, and provides full-duplex audio. It is easy-to-use, easy-to-install, and has a simple user interface software. The entire unit utilizes Power over Ethernet (PoE+). Intercom and paging functionalities† are built-in. - Page 3 INTERFACES (4) REMOTE PORTS (RMTCTRL) LEDS • Audio Out (Balanced) Power LED • Audio In (Balanced) • Red while booting • RS232 • Green when operational • 24VDC • Yellow when a recording from a classroom camera is happening. Status LED WALL PLATE AUDIO (WPA) PORT •...
- Page 4 Android Start the Device Configuration App. (Figure 1) Select the BLE dongle for the MS-700 you are configuring. If Multiple BLE dongles are found, select the dongle with the largest signal strength. Note that all MS-700s with a BLE dongle in range of the cell phone will be displayed.
- Page 5 Figure 1 Figure 2 Figure 3 Figure 4 Set default audio input levels. (Figure 5) Set audio output levels. (Figure 6) Set up the equalizer. In most cases the default settings work best in the classroom. (Figure 7) Figure 5 Figure 6 Figure 7 Link classroom microphones.
- Page 6 XD TEACHER MICROPHONE LINKING With the microphone off, press the Link With the microphone off, press button on the front of the amplifier or side of and hold REC button. Then the BEAM (Look for the blinking yellow LED). promptly press and hold PWR until microphone is linked.
- Page 7 XD STUDENT MICROPHONE LINKING With the microphone off, press the Link Press and hold the PWR LINK button on the front of the XD Receiver. button on the back of the XD (Look for the blinking yellow LED) Student Microphone. While holding use your thumb to slide the TALK button up into to the on position.
- Page 8 LINKING THE MEDIA CHANNEL The microphone cannot be linked to the Media channel unless MIC 1 and MIC 2 channels are on. Make sure the microphone needing to be linked, either the Teacher or Student, is turned off. Confirm that both Channel 1 and Channel 2 mics are on and connected to the amplifier. Follow XD Teacher or XD Student Microphone Linking section instructions.
- Page 9 XD TEACHER MICROPHONE VOLUME CONTROL Press SELECT to choose the desired source to control. An LED will illuminate to indicate the selected source. OWN will control the level of the microphone currently in use. CH3 will control the other microphone if a second microphone has been linked. Press the up arrow to increase the level of the selected source or the down arrow to decrease the level.
-
Page 10: Connector Details
CONNECTOR DETAILS Note that some Pin outs for the MS-700 are different than the MS-600. RMTCTRL PORTS WALL PLATE AUDIO +Line Level Output +Mic -Line Level Output -Mic RS232 - TXD I/O In #1 (Call) +24V dc +24V dc RS232 - RXD... -
Page 11: Troubleshooting
MS-700 AND SPEAKER VOLUME If you have speakers connected to an MS-700 with the volume at max and the sound is very quiet, the OHMs settings need to be changed in the software. The MS-700 will be defaulted to 2 OHMS and should read just when speakers are connected, but if this does not occur increase the OHM setting in the EPIC MS-700 software and volume will be corrected.
Need help?
Do you have a question about the MS-700 and is the answer not in the manual?
Questions and answers