Darkglass Electronics Microtubes X 900 Manual

Microtubes X 900 Manual – Darkglass Electronics

Specs

https://www.darkglass.com/microtubes-x-900-manual/[2/15/2024 11:11:09 AM]

Microtubes X 900 Manual

900W Bass Amplifier

Specs

Input : Use this jack to connect your instrument via a standard ¼" mono

cable.

Passive/Active : Use this push-button switch to change from passive to

active mode. If your bass is active it can have a hotter signal, making the

amp distort earlier (feel free to use if such additional distortion is desired).

X : Use this push-button to turn on or off the Microtubes X Engine which

allows you to compress and distort your bass signal in two separate bands,

solidifying the clean low end and distorting the highs to taste from

articulate to aggressive. The Microtubes X Engine operates before the EQ

section.

Clean Comp : Use this push-button switch to activate the compressor

circuit for the clean channel.

Vol (Clean Comp) : Sets the level of the clean channel when the

compressor is engaged.

HPF (High Pass Filter) : Controls the cutoff frequency of the high pass

filter which is applied before the clean signal is fed to the distortion

circuit. Ranging from 100 Hz (for thicker, fuzzier saturation) to 1 kHz (for

ultra-sharp definition).

Table of Contents

Do you have a question about the Microtubes X 900 and is the answer not in the manual?

Page 1 Microtubes X 900 Manual – Darkglass Electronics Microtubes X 900 Manual 900W Bass Amplifier Specs Specs Block Diagram Controls Warning Input : Use this jack to connect your instrument via a standard ¼” mono Warranty cable. Passive/Active : Use this push-button switch to change from passive to active mode.
Page 2 Microtubes X 900 Manual – Darkglass Electronics Drive : Sets the amount of distortion for the high pass side. Mix : Controls the blend between the compressed lows and the distorted highs. LPF (Low Pass Filter) : Controls the cut-off frequency of the low pass filter which is applied before the clean signal is fed to the compression circuit.
Page 3 No user serviceable parts inside the amplifier. Do not open the amp. Never use the amp in a high moisture environment or near liquids. The Microtubes X 900 can deliver more than 115 dB of power. Exposure to this level of sound can damage your hearing. Use proper hearing...
Page 4 Microtubes X 900 Manual – Darkglass Electronics protection if you will be exposed. The Microtubes X 900 can deliver more than 900 W RMS with a 4 Ω load. Be sure that your speaker cabinet is able to deliver that power.
Page 5 Microtubes X 900 Manual – Darkglass Electronics Electronics Oy. PRIVACY POLICYCAREERS DARKGLASS is a registered trademark in the U.S., number 4,616,801, owned by Darkglass Electronics Oy. Designed by Revolve Studio https://www.darkglass.com/microtubes-x-900-manual/[2/15/2024 11:11:09 AM]...