Kenwood KRC-580 Instruction Manual page 41

CD auto-changer section
Symptom
CD auto-changer mode
cannot be selected.
CD play does not start.
The specified disc is not
played; a different disc is
played instead.
Sound skips due to vibration,
Sound quality is poor.
No sound is heard even
though the information
concerning the CD auto-
changer is displayed.
The specified track is net
played.
3
Cause Remedy r—
CD auto-changer input is connected Connect the CD aute-changer input from o
fram the unit. the unit. @
Power button is not turned ON. Turn the power button ON, press the zs
SOURCE button, and select the CD auto- ie)
changer mode. oO
+
The disc is loaded upside dawn. Eject the disc magazine and insert the >
dise correctly. a
Two discs are inserted in a slot. Eject the disc magazine and insert the (2
discs correctly. c
The number of the slot into which the Eject the disc magazine and check the a.
'
disc is inserted is different irom the number of the specified disc.
number of the specified disc. :
The disc is severely damaged. 'Use a nother disc.
Something is touching the CD auto- Keep it away from the CD auto-changer.
changer.
The recording of the disc is poor. Try playing another cisc. lf the sound is
good, the fault was with the original disc.
Volume is set to minimum level. Raise the volume level.
The microcomputer does not function Press the Reset button on this unit.
correctly.
The system is not connected properly. Connect the system properly, See
"Cannections* (Page 37).
The player is set ta RANDOM Turn off RANDOM PLAY/MAGAZINE
PLAYAMAGAZINE RANDOM PLAY, RANDOM PLAY.
In some cases, you may see one of the following error messages on your unit's
y y g g Y
display
E-01: No disc magazine in changer. Disc magazine is not inserted properly.
ep insert the disc magazine properly.
E-02: No disc in disc magazine.
<> Load a disc in the disc magazine.
E-04: Disc is foo dirty. The disc is upside dawn, The disc is damaged.
=p Clean the disc and insert it correctly.
E-69: The unit malfunctions due to a defective CD mechanism. —
Press the Reset button. If the "E-09" message does not disappear, contact your Kenwood dealer.
HOLD: When the temperature exceeds 60°C, a protection circuit will stop all operations. This message will
then be displayed.
=>Let the place where the changer is located cool down. As soon as it has cooled, the changer starts
playing.
English 41