Advertisement
Installation Instructions
DRAINAGE
INTO A STANDPIPE
Hooked end
support
65mm (2'/,in) max.
40mm (1'/,in)min.
Standpipe height
INTO A SINK WASTE SYSTEM
Reposition hooked end
support and fix securely
800mm
(31'/,in)
min.
Standpipe height
INTO A SINK
Standard
imperial
or metric
worktop
height
Fit hose to waste
securely using a
'Jubilee' type clip
Sink drain
32mm
(1174n)
min.
WARNING: ONLY CONNECT YOUR MACHINE DRAIN HOSE
TO PIPES WHICH CONNECT TO THE FOUL DRAIN SYSTEM,
AND NOT TO SURFACE WATER DRAINS.
IMPORTANT NOTES: FOR THE CORRECT OPERATION OF
YOUR APPLIANCE IT IS ESSENTIAL TO COMPLY WITH THE
FOLLOWING INFORMATION.
DO NOT remove the hooked end support from drain hose and
ensure that the hose is not pushed too far down the standpipe.
If the end of your drain hose is fitted with 'retaining flaps',
ensure that they are fully inserted into the standpipe. This will
prevent the pipe from jumping out during installation and
machine use.
DO NOT position the standpipe near an electrical outlet.
ENSURE that the drain hose is routed as shown in the
diagrams - depending on the method of connection which you
choose.
The standpipe should be connected to -
a) A discharge stack-pipe
or
b) An external gulley
or
c) A sink waste.
The standpipe should have a bore of at least 38mm (1'/").
It should be installed as shown, have a trap fitted and must
discharge into the same drain system as your household sink.
It must NOT be connected to a surface water drain.
FOR UNDER SINK DRAINAGE: BEFORE CONNECTING
THE DRAIN HOSE, REMOVE ANY INTERNAL
RESTRICTIONS — THIS WILL PREVENT A BUILD UP OF
DEBRIS WHICH COULD CAUSE A BLOCKAGE.
Remove any restrictions from the waste spigot, and ensure
that the hose is routed such that it is raised to a minimum
height of 800mm (314).
Your machine will drain into a standard worktop sink, providing
the sink has an outlet pipe of at least 32mm (1'/,") inside
diameter.
Make sure that the sink plug, dishcloths, etc. do not fall into the
sink and block the outlet whilst the machine is working.
Ensure that the end of the drain hose is above the water level
in the sink to avoid syphoning.
If your sink is inset, the front edge of the basin must be less
than 75mm (3") from the front edge of your worktop.
Advertisement
