Panasonic DVD-CP67 Operating Instructions Manual page 19

solve the problem:
(http://www. panasonic.com).
Servicentre closest to you.
Power
No power.
The unit is automatically
switched to the standby mode.
Operation
No response when buttons
pressed.
No operations can be performed
with the remote control.
Play faits to start even when
[>] (PLAY) is pressed.
Play starts but then stops
immediately.
Cannot play DVD-Video.
Alternative languages fail to be
selected.
No menu play.
No subtitles.
Soundtrack and/or subtitle
language is not the one selected
with the SETUP menus.
Angle cannot be changed.
DIALOGUE ENHANCER has no
effect.
You have forgotten your ratings
password.
Reset ail the settings to Factory
Preset.
The drawer stops white
opening.
DVD-CP57
The progressive out indicator
does not light.
Sound
No sound.
Distorted sound.
Piercing noise comes from the
speakers.
_ eE Ensure that the disc is installed with the label of the side to be played facing upwards.
Page
_e Insert the AC power supply cord securely into the household AC outlet.
eTo conserve power, the unit automatically switches to standby after approximately 30 minutes in
the stop mode. Turn the power back to ON.
eThe unit was switched to standby by the SLEEP timer.
Some operations may be prohibited by the disc.
e The unit may not be operating properly due to lightning, static electricity or some other external
factor.
Reset procedure:
Press [POWER (} to switch the unit to the standby mode and then back to ON.
Alternatively, press (POWER ()] to switch the unit to the standby mode, disconnect the AC power
supply cord, and then reconnect it.
eCheck that the batteries are installed correctly.
+The batteries are depleted: Replace them with new ones.
ePoint the remote control at the remote control signal sensor and operate.
Condensation has formed: Wait 1 to 2 hours for it to evaporate.
eThis unit cannot play discs other than DVD-Video, CD and Video CD.
eYou can only play DVD-Video if their region number is "3", "ALL" or multiple region number
including "1".
eThe disc may be dirty and may require cleaning.
eThe sequential mode is on. Press [SEQUENTIAL] ([CD SEQUENTIAL]) to turn the sequential
mode off,
*An alternative language is not selected with discs which do not contain more than one language.
e In the case of some discs, the alternative language cannot be selected with [AUDIO] or
Ref 57
[SUBTITLE]. Tr ry selecting it from the disc's menu if one is available.
e Menus are only displayed if they are recorded on the disc.
è Subtitles appear only with discs that contain them,
*Subtitles are cleared from the television, Display the subtitles.
©The language is not recorded on the disc.
eThis function is dependent on software availability. Even if a disc has a number of angles
recorded, these angles may be recorded for specific scenes only.
eThis feature does not work when the unit is outputting bitstream signals.
eWhile stopped, press and hold [ kid] and [14] on the unit and then also press and hold [A]
on the unit until "initialized" disappears from the television. Turn the unit off and on again.
All settings will return to the default values.
eli possible, remove the discs at the front of the drawer, then turn the unit off and back on again.
«Go to the Video menu in the SETUP menus, and select "Enable" in "Progressive Out'.
Check the connections.
eCheck the volume on the equipment you have connected.
eEnsure that the input settings for the television and stereo system are correct.
eTurn ADVANCED SURROUND off if it causes distortion.
A e gS ia
eli you have connected this unit to other equipment through the DIGITAL AUDIO OUT terminal,
ensure you have selected the correct settings for "Dolby Digital", "DTS Digital Surround" in the
SETUP menu's Audio menu.