Select Boot Devices; Open The Uefi/Bios Setup Utility; Change Hotkey Mode; Set Passwords In Uefi/Bios Setup Utility - Lenovo LOQ 15AHP9 User Manual

Table of Contents

Advertisement

Select boot devices

Normally, the computer starts with a boot manager loaded from the secondary storage device of the
computer. Occasionally, you may need to start the computer with a program or boot manager loaded from
another device or a network location. After the system firmware initializes all devices, you can press an
interruption key to display the boot menu and select a desired boot device.
Step 1.
Turn on or restart the computer.
Step 2.
Press F12.
Step 3.
From the boot device menu, select a boot device to start the computer.
You can make a permanent change on boot devices in the UEFI/BIOS setup utility. Select the Boot menu; in
the EFI section, select the desired boot device and move it to the top of the device list. Save changes and
exit the setup utility for the change to take effect.

Open the UEFI/BIOS setup utility

Step 1.
Turn on or restart the computer.
Step 2.
Before the Lenovo logo appears on the screen, press F2 repeatedly.
Step 3.
Select UEFI/BIOS Setup.

Change hotkey mode

Step 1.
Open the UEFI/BIOS setup utility.
Step 2.
Select Configuration ➙ Hotkey Mode and press Enter.
Step 3.
Change the setting to Disabled or Enabled.
Select Exit ➙ Exit Saving Changes.
Step 4.

Set passwords in UEFI/BIOS setup utility

This section introduces the types of passwords that you can set in the UEFI (Unified Extensible Firmware
Interface) or BIOS (Basic Input/Output System) setup utility.

Password types

You can set various types of passwords in the UEFI/BIOS setup utility.
Password type
Administrator password
User password
Master hard disk password
User hard disk password
Notes:
• All passwords set in the setup utility consist of alphanumeric characters only.
28
User Guide
Pre-requisite
No
The administrator password must be
set.
No
The master hard disk password must
be set.
Usage
You must enter it to start the setup
utility.
You can use the user password to
start the setup utility.
You must enter it to start the
operating system.
You can use the user hard disk
password to start the operating
system.

Advertisement

Table of Contents
loading

Table of Contents