Related Manuals for ALCO TILT AL-83874
Summary of Contents for ALCO TILT AL-83874
- Page 1 Installation and User Manual AL-83874 TILT™ Toilet Incline Lift Visit www.alcosales.com for product specifications 1-800-323-4282 Manufactured in the USA...
-
Page 2: Symbol Meanings
INTRODUCTION Thank you for purchasing the TILT™ Toilet Incline Lift (TILT). Please read these instructions entirely before installing or using your new TILT. After installation, it’s important that you raise and lower the TILT 3-4 times, without sitting on the seat, to learn its functionality. -
Page 3: Box Contents
WARNING! Rated load: 325 lbs. NEVER EXCEED RATED LOAD. Use the TILT only with a qualified helper. Manufacturer recommends professional installation and maintenance. Read this manual in its entirety before installation. Understand and learn the location and function of all the features, safety devices, and labels before operating. -
Page 4: Hardware Contents
HARDWARE CONTENTS DESCRIPTION VISUAL PLASTIC TOWER NUT WASHER FLAT .375 X .875 X .06 TEFLON BOLT HEX .375-16 X 1.75 GRADE 18-8, PARTIAL THREAD OVERVIEW REFERENCE DESCRIPTION PLASTIC SHIELD - REMOVABLE TOILET SEAT – STANDARD SEAT SHOWN HANDLES WITH FOAM GRIP LINEAR ACTUATOR –... -
Page 5: Getting Started
GETTING STARTED 1. Before installation, ensure that there is enough space for proper TILT operation. Six inches is needed on either side of the toilet bowl, and 7-1/2 inches is needed in front of the bowl. INSTALLATION 2. FRAME INSTALLATION Remove the existing seat and lid from the toilet bowl, and then set aside. - Page 6 CONTROL MOUNT With the TILT frame bolted to the toilet, pull the two handles ① forward until the seat is fully raised and slightly overextend (this will allow the seat to stay in the “up” position while the motor is being placed and mounted). For clarity, image is shown without Linear Actuator attached.
- Page 7 LINEAR ACTUATOR Using the blue dots on upper actuator bracket ③ and linear actuator ④ as guides, hold linear actuator ① and lower the seat to align the control mount slot with the top of the actuator bracket ②. Once aligned, fully insert the pin into actuator arm until it stops.
- Page 8 5. TEST TILT ACTION Plug the 120VAC TILT cord into a properly grounded GFCI protected outlet. If you are unsure if you have a properly grounded GFCI outlet, contact an electrician for assistance. Do not remove the round grounding prong from any plug. 6.
- Page 9 8. CLEANING Do NOT use toilet bowl cleaner to clean the TILT or any of its components. For hygiene and safety, proper cleaning and inspection of the TILT is essential. Carefully remove 120V plug from the wall. To access the removable plastic shield, use the push button control to raise the TILT into its “up” position. 8.4.1 Remove the plastic shield by grabbing it from the front and pulling upward then forward until the shield slides off from the support rollers.
Need help?
Do you have a question about the TILT AL-83874 and is the answer not in the manual?
Questions and answers