Overview Remote Control; Putting Into Operation - easymaxx NC2445/4SCB Operating Instructions Manual

OVERVIEW REMOTE
CONTROL
9
8
7
1 OFF button
2 ON button
3 FLASH (flash function RGB + W
+ mixed colours)
4 STROBE (flash function RGB)
5 FADE (smooth change of colour) RGB)
6 SMOOTH (colour gradient RGB + W
+ mixed colours)
7 Control pad for colour selection
(12 mixed colours)
8 Setting RGB + W
(Red, Green, Blue, White)
9 Brightness setting
PUTTING INTO
OPERATION
Please Note
■
Use suitable fixings to hang up on the
wall. If you are uncertain, seek advice
from a specialist stockist.
■
Before drilling, ensure that there are
no pipes or cables behind the intended
drilling point.
■
Do not charge on a computer because
the high charging current could dam-
age the computer.
01947_01948_01949_01950_01950_DE-EN-FR-NL_A5_V2.indb 11 01947_01948_01949_01950_01950_DE-EN-FR-NL_A5_V2.indb 11
1. Select and insert: Insert the letters /
emojis you want into the rails of the
product. When you do this, make sure
that they fit in the rails at the top and
1
bottom.
2
2. Insert batteries (see the "Inserting /
Changing Batteries" chapter) or
connect the product via the cable
3
supplied to a power source, ideally
4 with a mains adapter to a plug socket.
The socket for the barrel connector
5
of the cable is located on the side or
6
bottom of the product.
3. Hang up / set up: Set up the product
on a flat, dry surface or hang it on the
wall.
4. Switch on / off: Move the On / Off
switch to the I position to switch on
the product.
To switch the product off again, move
the On / Off switch to the 0 position.
5. Selecting a colour – Press the corre-
sponding colour selection button (7,
9) on the remote control to switch
between the different colours.
6. Setting the mode – Press the corre-
sponding mode button (3 – 6) on the
remote control to switch between the
different modes.
7. Setting the brightness – Set the bright-
ness via the
8. Turning LEDs on / off – To turn the
LEDs on or off, press the ON (2) or
OFF button (1) on the remote control.
L
All the buttons on the remote
control only work if the On / Off
switch has previously been set to
the I position.
and buttons (9).
21.10.2022 08:35:59 21.10.2022 08:35:59
EN
11