Page 2
Use Environment Safety Instructions Product Specifications Name Of Each Part control panel Remote control Operation other functions Preparation for using remote control Precautions for using remote control Cleaning and maintenance Installation precautions Preparation before installation Drainage method Installation and removal of heat discharge pipe Precautions for installing heat discharge pipe Install window isolation panels Troubleshooting...
●Please keep the air inlet and outlet clean and free of obstacles. ●Please close the doors and windows when using to improve the cooling/heating effect. ●To avoid abnormal situations such as noise and vibration of the air conditioner, please place the air KYR-35A1 Model No. conditioner on a flat ground.
Name Of Each Part Of The Product Control Panel Front Back Control Panel Wind speed Mode indicator light indicator light COOL DEHU speed button mode MODE HEAT AUTO SPEED Timer LEFT/RIGHT indicator light ANION indicator light Timer button ON/OFF button TIMER WIND UP/DOWN WIND L/R...
Page 5
ON/OFF When the power is turned on, the machine emits a beep sound (refer to the power parameters on the nameplate to connect to the power), and the machine enters standby mode. At this time, the machine can be controlled using the control panel or remote control. WIND SPEED Press the standby button , the machine will start up, enter default mode, and the corresponding...
OTHER FUNCTIONS Cleaning and maintenance Defrost Warning The machine has an automatic defrosting function, which automatically detects the tempera- Before cleaning the air conditioner, it must be turned off and the power must be cut off, ture and determines whether defrosting is needed during operation, ensuring that the machine otherwise there is a risk of electric shock.
Page 7
Inspection before the usage season Installation precautions Attention 1.Check if the air inlet and outlet are blocked. 2.Check if the plug and socket are in good condition. 1.Please comply with all local laws and regulations during installation. 3.Check if the filter is clean. 2.Do not use damaged or non-standard power cords.
Page 8
Preparation before installation Drainage method Tip: Please check if the accessories are complete before installation. When operating in cool mode, manual drainage is generally not required, but when operating in high temperature and high humidity environments, there may be a situation of water full, which requires manual or continuous drainage.
Page 9
Installation and removal Precautions for installing heat discharge pipe of heat discharge pipe In order to improve refrigeration efficiency, the installation of heat pipes should be as short and flat as possible, without distortion, and to maintain the smoothness of the Installation heat discharge pipe.
Page 10
Install window isolation panels 4. Adjust the position of plates A and C on board B through the sliding groove on board B to reach the required length. Then, tighten the butterfly nut clockwise to the end to firmly fix the relative positions of plates A, B, and C. 1.After threading the screw through the hole on the isolation plate A, place a flat gasket on the screw and tighten the nut.
OTHER FUNCTIONS Low voltage? Wait for the voltage to return to normal. Dirty filter? Clean the filter General analysis Proper temperature? Adjust to the proper temperature. Cooling (heating) Please press the following table for troubleshooting before contacting the maintenance. If the is not good Doors and windows are closed? Close the doors and windows.
Need help?
Do you have a question about the KYR-35A1 and is the answer not in the manual?
Questions and answers
Any solution for drain pipe falling off Very loose, leaks Can’t get a tie wrap on it