Advertisement
Adjusting the Horizontal Position and Tilt of the Flat Panel Screen
For horizontal adjustment, slide screen from side to
3
side. If grommets are attached, the screen must be
picked up and placed in new position as shown in
figure 3.1.
Insert wrench (HH) through mount (AA) to adjust
4
tension screw, shown in figure 4.2 and detail 1, to
desired tension to balance your screen size and
weight. Desired tension is achieved when screen tilts
easily and stays in place.
Note: Tension screw is only on right side of mount
Push or pull from top or bottom of screen to adjust
tilt as shown in figure 4.1. The tilt can be adjusted to
a maximum of 15° forward or 5° backward.
To lock the screen into the desired position, tighten
tension screw using wrench.
CAUTION
• Do not tighten screws with excessive force.
Overtightening can cause damage to mount. Tighten
screws to 40 in. • lb (4.5 N.M.) maximum torque.
• Be careful not to pinch fingers when pushing screen
from the bottom.
fig. 4.2
Visit the Westinghouse Web Site at www.westinghousedigital.com
CAUTION
AA
HH
7 of 9
fig. 4.1
TENSION
HH
DETAIL 1
ISSUED: 03-02-05 SHEET #: 201-9324-1
For customer service call 1-866-287-5555.
fig. 3.1
Advertisement
