Basic Settings - Medion MSH 1000 Instruction Manual

Basic Settings

After switching on the receiver for the first time or after using the Factory Reset function
you will be asked to choose your OSD language and your geographical location. The re-
ceiver will also offer you the choice to perform a channel scan or if available to use a pre-
programmed channel list for your location. Note: these channel lists are only up-to-date
when the receiver is produced or a software update has been performed. Afterwards you
should perform the following steps:
1. Open the main menu.
2. Go to "Edit Settings"
3. Go to "Signal Output". Select the screen format for your TV.
4. If you wish to control the volume through your receiver go to
point 5 of these instructions.
Reduce the volume of your TV and amplifier (Hi-Fi) to it's mini-
mum before carrying out the following steps.
If you wish to control volume from the connected device (amplifier,
TV, etc.) go to the heading "Volume-bypass" and choose the out-
puts for the source of the full volume level.
5. Leave the "Signal Output" menu by pressing EXIT and move to the
heading "Save Settings". Press OK and wait until the menu disap-
pears.
36
Press MENU
button twice
– / +
– / +
OK
MSH 1000