Table of Contents
Advertisement
Use the 4 internal fixing points if the
opening is 600 mm.
A combination of both fixing methods can
be used if required.
14.5 Using the 2 external
brackets
1. Install the brackets in the slots on the
top of the appliance.
This operation must be done before
the appliance is positioned under the
counter.
D
2. Install the appliance under the
counter. Make sure that the
appliance is levelled properly.
3. Fix the brackets (on the top or on the
side) with the screws supplied. Make
sure that the screws are tight.
A
A
14.6 Using the 4 internal
fixing points
1. Install the appliance under the
counter. Make sure that the
appliance is levelled properly.
D
A
A
2. Fix the appliance laterally with the
spacers and the screws supplied.
Make sure that the screws are tight.
C
B
14.7 Water inlet hose
Connect the inlet hose to a water tap
with an external BSP thread spout of
3/4''.
For best washing performance, it is
recommended to connect the appliance
to a cold water supply.
Energy savings can be made by
connecting the appliance to a Solar
water system and using economy
options, however the water temperature
must not exceed 60° C.
Inlet water supply
• Water pressure: 1000 kPa max - 50
kPa min.
• Water flow rate 10 L / minute min.
• If water pressure is in excess of 1000
kPa, a pressure reducing valve should
be used. Check for leaks.
• If water temperature is in excess of
60° C, a tempering valve should be
used. Check for leaks.
CAUTION!
Always use new hoses when
you connect the appliance to
the water mains. Old hoses
must not be used. The water
inlet hose must be examined
at an interval of twelve
months for deterioration and
replaced if necessary.
The water pressure must be in the limits
indicated in the chapter ''TECHNICAL
INFORMATION''. Make sure that the
local water authority gives you the
average mains pressure in your area.
ENGLISH
25
C
B
Advertisement
Table of Contents
