Night Light - Philips AJ 3600 Quick Start Manual

CLOCK RADIO_ ALARM
RADIO
You may use the appliance simply as a radio.
Switching on the radio
• Set function switch ©to RADIO ON. The radio will
now come on.
• Select the waveband with the BAND switch
• Select the required station with the TUNING
knob
• The sound level is adjusted with the aid of the
VOLUME control ©
Switching off the radio
You can switch off the radio by setting function
switch © to OFF.
Aerials
The AM aerial is built into the appliance. You may
have to adjust the position of the clock radio slightly
for better reception.
For FM reception there is an aerial wire at the rear of
the appliance. You should extend this wire and adjust
slightly to obtain optimum reception.
NIGHT LIGHT
The clock radio has a built-in night light. The light
sensor © ensures that the strength of the night light
is adapted to the light in the room.
Set the light switch @ to;
- HIGH if you require bright light.
- LOW if you require dimmed light.
- OFF if you wish to switch the night light off.
ALARM
Alarm time
If you wish to use the alarm, then you should first of
all set the alarm time.
The alarm time is the time when you wish to be woken
up. You may set two different alarm times. This can
be useful if, for example, you need to be woken at a
different time during the week than at the weekend.
Note: With alarm 1 you will always be woken by the
radio and with alarm 2 by the buzzer. During the
week, for example, you may choose to be woken by
the buzzer (alarm 2) and at the weekend by the radio
(alarm 1).
Setting alarm time 1
• Press ALARM 1 button © The display will now
show alarm time 1.
• Keep button @ depressed and set the required
alarm time with the ^
^ buttons @ and ^ H- ▼
buttons ®,
• Release ALARM 1 button ©.The display will again
show the correct time.
You can check alarm time 1 by simply pressing
button ©
Setting alarm time 2
• Press ALARM 2 button ©. The display will now
show alarm time 2.
• Keep button © depressed and set the required
alarm time with the ^ + ^®and^ -F '^©buttons.
• Release ALARM 2 button © The display will again
show the correct time.
You can check alarm time 2 by simply pressing
button ©.
5