1. Manuals
  2. Brands
  3. Traxxas Manuals
  4. Motorized Toy Car
  5. Fiesta ST Rally BRUSHLESS
  6. Owner's manual

Traxxas Fiesta ST Rally BRUSHLESS Owner's Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
MODEL 74154-4
owner
s manual
'

Advertisement

Table of Contents
loading

Related Manuals for Traxxas Fiesta ST Rally BRUSHLESS

Summary of Contents for Traxxas Fiesta ST Rally BRUSHLESS

  • Page 1 MODEL 74154-4 owner s manual ’...
  • Page 2 The Traxxas 1/10 Ford Fiesta® ST Rally delivers blistering rally-racing PROCEED Traxxas Support performance on the pavement or in the dirt. The Traxxas Ford Fiesta® Traxxas support is with you every step of the ST Rally is specially tuned with a low-CG chassis and oil-filled Ultra way.

  • Page 3: Before You Proceed

    Traxxas service needs. Maintenance and replacement identified by the icons below. Be sure to read them! To-Win, BL-2s, and ProGraphix parts may be purchased directly from Traxxas by phone or online are trademarks or registered An important warning about personal safety or avoiding at Traxxas.com.

  • Page 4: Safety Precautions

    SAFETY PRECAUTIONS All of us at Traxxas want you to safely enjoy your new model. Operate • Insulate the Wires: Always insulate exposed wiring with heat shrink your model sensibly and with care, and it will be exciting, safe, and tubing to prevent short circuits.
  • Page 5 • ONLY use a Traxxas iD charger to charge Traxxas iD batteries. identifying the battery type and specifications. ONLY use a Lithium Polymer (LiPo) balance charger with a •...
  • Page 6 SAFETY PRECAUTIONS (continued from previous page) • While charging or discharging, ALWAYS place the battery (all • If a battery gets hot to the touch during the charging process types of batteries) in a fire retardant/fire proof container and on (temperature greater than 110°F / 43°C), immediately disconnect a non-flammable surface such as concrete.

  • Page 7: Tools, Supplies, And Required Equipment

    8mm/4mm wrench 4-way wrench model, but are a good idea to include in any RC toolbox: • Safety glasses • Traxxas Ultra Premium Tire Glue, part #6468 (CA glue) • Hobby knife • Side cutters and/or needle nose pliers Various pre-load spacers...

  • Page 8: Model Overview

    MODEL OVERVIEW Spur Gear Battery Hold-Down Motor Traxxas High-Current Connector Steering Block Caster Block Front Suspension Arm Shock Half Shaft Battery Compartment Left Clipless Body Mount Drive Shaft Front Bumper Rear Shock Tower Chassis Rear Bumper Rear Body Mount Steering Servo...

  • Page 9: Quick Start: Getting Up To Speed

    QUICK START: GETTING UP TO SPEED The following guide is an overview of the procedures for getting your model running. Look for the Quick Start logo on the bottom corners of Quick Start pages. The Quick Start Guide is not intended to replace the 1.
  • Page 10 TRAXXAS TQ 2.4GHz RADIO SYSTEM INTRODUCTION power more efficiently than mechanical speed controls so that Your model includes the TQ 2.4GHz transmitter. When powered the batteries run longer. An electronic speed control also has Applying the Decals on, the TQ 2.4GHz will automatically locate and lock onto an...
  • Page 11 TRAXXAS TQ 2.4GHz RADIO SYSTEM Resistance - In an electrical sense, resistance is a measure of how 2-channel radio system - The TQ radio system, consisting of an object resists or obstructs the flow of current through it. the receiver, the transmitter, and the servos. The system uses To prevent loss of radio range, When flow is constricted, energy is converted to heat and is lost.
  • Page 12 TRAXXAS TQ 2.4GHz RADIO SYSTEM Your model is equipped with the Traxxas TQ 2.4GHz transmitter. MODEL WIRING DIAGRAM BL-2s Wiring Diagram The transmitter has two channels: Channel one operates the Motor steering, and channel two operates the throttle. The receiver...
  • Page 13 LED does not indicate the charge level of the battery pack to avoid losing control. select. Traxxas recommends you choose a genuine Traxxas EZ-Peak iD installed in the model. Refer to the Troubleshooting section charger for safer charging and maximum battery life and performance.
  • Page 14 TRAXXAS TQ 2.4GHz RADIO SYSTEM To reinstall the body: INSTALLING THE BODY 1. Insert the front and rear body posts in the front and rear body Your model includes an innovative latching system for securing the Battery iD mounts on the chassis.
  • Page 15 Secure, long-lasting, and easy reduced radio range and slide the antenna wire into the bottom to grip, the Traxxas connector is engineered to extract all the power potential loss of control. Antenna of the antenna tube until the white your battery has to give.
  • Page 16 TRAXXAS TQ 2.4GHz RADIO SYSTEM RADIO SYSTEM CONTROLS • In order for the transmitter and receiver to bind to one another, Remember, always turn the the receiver in the model must be turned on within 20 seconds transmitter on first and off of turning on the transmitter.
  • Page 17 TRAXXAS TQ 2.4GHz RADIO SYSTEM Throttle reversing procedure: 6. When looking down at the Note: Throttle reversing is often times unnecessary on electric model, the front wheels Using Reverse: While driving, models, as issues with the throttle can usually be solved by...
  • Page 18 TRAXXAS TQ 2.4GHz RADIO SYSTEM Higher Speeds Require Greater Distance TQ 2.4GHz Binding Instructions The faster you drive your model, the more quickly it will near the For proper operation, the transmitter and receiver must be Failsafe limit of radio range. At top speeds, models can cover anywhere electronically ‘bound.’...

  • Page 19: Adjusting The Electronic Speed Control

    1. Turn the transmitter off. transmission on high-traction surfaces. 2. Hold both MENU and SET. 7. To turn the BL-2s off, press the EZ-Set button until the LED turns TRAXXAS • 19 3. Turn the transmitter on. off (.5 seconds).
  • Page 20 ADJUSTING THE ELECTRONIC SPEED CONTROL BL-2s Profile Selection 4. The LED will blink and then turn solid Patented Training Mode The speed control is factory set to Profile #1 (100% forward, brakes, and reverse). green (Low-Voltage Detection ACTIVE) or (Profile #3) reduces forward To disable reverse (Profile #2) or to allow 50% forward and 50% reverse (Profile #3), red (Low-Voltage Detection DISABLED).

  • Page 21: Driving Your Model

    • The Traxxas TQ 2.4GHz transmitter is not water resistant. Do not subject it to speed and with repetitive hard acceleration.
  • Page 22 DRIVING YOUR MODEL • Do not operate your model during a rain storm or other inclement After Running Your Vehicle in Wet Conditions 1. Drain the tires by spinning the tires at high speed to “sling” the weather where lightning may be present. water out.
  • Page 23 DRIVING YOUR MODEL RECEIVER BOX: MAINTAINING A WATERTIGHT SEAL Removing and Installing Radio Gear The unique design of the receiver box allows the removal and installation of the receiver without losing the ability to maintain a watertight seal in the box. The patent-pending wire clamp feature gives you the ability to also install aftermarket radio systems and maintain the watertight features of the receiver box.

  • Page 24: Adjusting Your Model

    ADJUSTING YOUR MODEL Gearing Compatibility Chart: Once you become familiar with driving your model, you might need Fine Tuning the Shocks The chart below shows to make adjustments for better driving performance. The four shocks on the model greatly recommended gear combination influence its handling.
  • Page 25 ADJUSTING YOUR MODEL Centering Your Servo If you are worried that you might be over-geared, check the If you have removed the servo horn from your model’s steering servo, temperature of the battery pack and motor. If the battery is extremely To achieve a good starting or the servo has been removed for service or cleaning, the servo must hot, and/or the motor is too hot to touch, your model is probably...
  • Page 26 Most will affect the overall width and the suspension Only use silicone oil in the differentials. Traxxas offers SAE 10,000W, geometry of the model. The offsets and dimensions designed 30,000W, and 50,000W viscosity oil (see your parts list).
  • Page 27 Rear differential: Refilling the differential: 1. Remove the two 3x20mm button-head screws that secure the 1. Remove the four 2.5x8mm screws from the differential case and top bumper mount to the differential case. carefully pull the differential case halves apart. Work over a towel to collect any fluid that drips from the differential.

  • Page 28: Maintaining Your Model

    If the bottom of the shock is leaking, then it 6. Check the tightness of the wheel nuts with a wrench. is time for a rebuild. The Traxxas rebuild kit for two shocks is 7. Check the operation of the radio system, especially the part #2362.
  • Page 29 MAINTAINING YOUR MODEL Suspension and slipper clutch assembly removal Removing the rear suspension module (slipper clutch assembly Your model was designed with ease of disassembly in mind. The entire removal) front and rear suspension assemblies can be removed from the chassis 1.
  • Page 30 ’ 6250 TRAXXAS WAY, McKINNEY, TEXAS 75070 1-888-TRAXXAS 231130 74154-4-OM-EN-R00...

This manual is also suitable for:

74154-4

Table of Contents