B. Leaving the programming mode
Press the CHORUS button.
C)
(C0
The flashing will stop, and you will return to the tone in effect when you entered the
programming mode.
You can also continue into another programming mode by pressing
another TONE SELECTOR without pressing the CHORUS button.
2 | Changing the SPLIT Point (CA840 & CA640 only)
Make sure that the piano is in the programming mode.
Press the SPLIT button so that it flashes to indicate that the piano is waiting for a
SPLIT point specification.
c>
a0
e
Press the key corresponding to the lowest note for the desired UPPER range. For
example, pressing the lowest key on the keyboard would make the entire keyboard
as the UPPER.
E
cor
ee
000900
BO090950 50.5 cates go
g
pA AAAA
Lower Tone
Upper Tone
Leave the programming mode by pressing the CHORUS button.
-
23 -