Table of Contents
Advertisement
CD SYNCHRO (CD synchronized recording) section
(The playback of the Sony CD player equipped with a
remote commander and the recording of the cassette
deck can be performed simultaneously.)
SYNCHRO: Press to start recording of the cassette deck
equipped with the multi-changer and then playback of
the CD player.
STAND BY: Press to set the cassette deck to the record-
standby mode.
-
START: Press to start recording of the cassette deck and
then playback of the CD player.
STOP: Press to stop the recording of the cassette deck
and playback of the CD player.
[8] Amplifier/TV section
TVMIDEO button: Selects the input signal of the TV.
(for TV)
Program number (1 to 0) and ENTER buttons: Select
the channel. (for TV)
SURROUND mode selectors (for the AV amplifier)
ON/OFF: Turns on/off the surround mode.
MODE: Selects the surround mode.
T.(test) TONE: Outputs test tone' to each speakers in
'succession.
DELAY: Adjusts the delay time.
FUNCTION selectors: Select an input source of the AV
~ amplifier. (for the AV amplifier)
(The VIDEO 2, 3 and 4 do not function. When the
VIDEO 1 button is pressed, the AV amplifier enters the
VIDEO mode.)
CENTER VOL /TV VOL +/- buttons: Control the volume
of center speaker or TV. (The CENTER VOL +/-
buttons function for the AV amplifier.)
REAR VOL /TV CH +/- buttons: Control the volume of
rear speakers or channel of TV. (The REAR VOL +/-
buttons function for the AV amplifier.)
DBFB button: Turns on/off the DBFB (Dynamic Bass
Feed Back). (for the AV amplifier)
MASTER VOL +/- buttons: Control! the amplifier's master
volume. (for the AV amplifier)
|
fe] Reset button
Reset the commander to the initial state.
Note on the @ (recording) button under [6] Tape deck/DAT/VCR
control section
If your recorder is of such type as pressing @ puts it in recording
pause mode, first press @ on this commander and then #4.
Note
The </> (play) buttons in 4) and [) and the SHIFT button, PRESET
+/- buttons in &] and CD SYNCHRO buttons in [7] can function
without pressing one of the FUNCTION buttons in &].
Inserting the batteries into the remote commander
": Qinsert two size-AA (R6)
batteries with correct
1 Open the cover.
Battery life
About half a year of normal operation can be expected
when using the Sony SUM-3 (NS) batteries.
When the batteries are exhausted, the commander can no
longer operate the unit. Replace both batteries with new
ones.
To avoid battery leakage
When the commander is not to be used for a long period of
time, remove the batteries to avoid damage caused by
battery leakage and corrosion.
'
To avoid malfunction of the remote commander
Avoid keeping the remote commander under extremely hot
or humid locations.
Advertisement
Table of Contents
