Table of Contents
Advertisement
SIU] 9) e) I {=xe| Remote Commander.
porary
passe
toe terp cd racan tenga
cee
PIMA L2G.
Lt
r i e s
When you manipulate a switch or button on the commander,
be sure to point the head of the commander toward the
remote control sensor on the front of the AV amplifier. If
there is an obstacle between the AV amplifier and the head
@Press and hold the button which shall
of the commander, the AV amplifier may not be controlled
"learn" the remote-control signal until
:
:
5
:
—->
xy
Programming Signals of Other Audio/Video
LEARN AS
Equipment
;
The RM-P322 learns various functions of other remote
2 Program a signal.
commanders emitting infrared rays arid allows you to
SS
=
papeess om
control most of audio and video equipment from a distance.
S
reg
eee
Other manufacturer's
remote commander
Programmable
commander RM-P322
@Press and hold the
@Remove your finger(s)
button of other
froin the button(s) after
manufacturer's remote
~
the LEARN indicator
commander whose
goes off.
signal is to be learned.
1 Set the mode selector to LEARN.
3 Repeat operation for each button to be
programmed.
USER STD
STD
LEARN
—y
4 Set the mode selector to USER STD or SONY
STD.
USER STD
SONY
LEARN
=
STD
The two remote commanders must:
¢ face straight each other.
© be placed at a distance of approx. 5 cm (2 inches).
¢ not be moved during programming operation.
After programming
Be sure to test if the equipment really works with the
programmed signals.
Number of signals that the commander can learn
It depends on the format of the signal. If you program
signals of Sony equipment, approximately 50 - 60 signals
can be programmed.
13
Advertisement
Table of Contents
