Advertisement
@PANEL DESCRIPTIONS
einput Jacks
These are to connect audio equipment,
musical instruments, micropnone, etc.
eEffect Send Jack
This is to connect the Input of the effect
unit.
eEffect Return Jack
This is to connect the Output of the effect
unit,
Output Jacks
These are to connect a power amplifier
or recording equipment, etc.
Power Switch
Be sure to turn the Power Switch on or
off with the Master Volume set low.
*Overload indicator
This lights when input signal level is too
high. Adjust the level lower than that by
using the Gain Control.
Gain Controls
This knob is to set the Gain level depend-
ing on the connected unit. Rotating this
clockwise increases the level.
®Treble Controls
This knob adjust the treble. That is, rotat-
ing it clockwise boosts the high frequency
range, and rotating it counterclockwise
cuts it.
«Bass Controis
This adjusts bass sound. Rotating this
clockwise boosts iow frequency range,
and rotating it counterclockwise cuts it.
*When these knobs are set to zero, there
is no boost or cutoff of harmonic con-
tents, therefore flat characteristics are
obtained.
eEffect Level Controis
This sets the level of the output signal
sent to each effect unit(=Effect send
level}.
* The pickup point of the Effect Send signal
is post channe! volume.
ePanpot Controls
The
Panpot
Control
routes the input
signal from an Input Channel to the left
and/or right mixing busses. By means of
the Panpot Controis, input signals can be
sent exclusively to one mixing bus, or
the other, to both mixing busses equally,
or since the Panpot Control is continu-
ously variable to both mixing busses in
any relative proportion desired.
important Notes
©The BX-800 may become warm during operation, but
this is quite a normal situation caused by AC pow-
ered operation, so there is nothing to worry about it.
eChannel Volumes
This knob controls the volume of each
channel
independently.
The "10" posi-
tion gives the highest and "0" lowest
level.
Level Indicators
This detects the level of the output signal.
When "OdB" lights, the signal of +4dBm
is being sent through the Output Jack.
Power Indicator
This lights when the BX-800 is turned on.
eEffect Return Level Contro!
This knob controls the volume of efg
sound. As you rotate it clockwise,
l )
volume increases.
Headphone Level Control
As you rotate this knob clockwise, the
headphones volume increases.
This knob allows separate level setting
tree from the Master Volume.
eHeadphone Jack
This can be connected to headphones.
Master Volume
These
are
two
independent
controls
which control the volume of the lett and
right channels, thus acting as an overall
volume controls for the BX-800.
At the "10"
position,
the volume
is
highest, and at '0' lowest.
elf the BX-800 is not in use, turn it off.
Please avoid using the BX-800 in extreme heat or
humidity or where it may be affected by dust.
Advertisement
