Assembly & Installation (Non-Fsm) - Diamond Engineering DAMS 000 Series User Manual

Assembly & Installation (Non-FSM)
Introduction
BEFORE YOU BEGIN: Unpack ALL items and ensure there are no damaged or missing parts.
NOTE: The x000 Series is designed for non-FSM measurements using elevation motor.
Vertical Assembly
1. Unfold tripod and extend the top half-way, then secure the height adjustment. (Fig. 1)
2. Take the grey vertical spacer and snap it onto the very top of the tripod neck. (Fig. 2)
IMPORTANT: Without this piece, your unit will not make accurate vertical measurements.
3. Attach the vertical assembly onto the top of the tripod using the included hex wrench so the top
edge of the vertical assembly is touching the bottom edge of the vertical spacer. (Fig. 3)
Fig. 1
Extend tripod
Fig. 2
Attach vertical spacer
9
Fig. 3
Attach vertical assembly
ensuring vertical actuator rod
does not hit tripod legs as it
moves down
(Continues on next page...)
x000 Installation & Configuration