GE JVM3150 Installation Instructions Manual page 12

Installation Instructions
A_|OUTSIDE TOP EXHAUST Vertical Duct)
INSTALLATION OVERVIEW
A1. Attach Mounting Plate to Wall
A2. Prepare Top Cabinet
A3. Install Adapter
A4. Mount Oven
A5. Adjust Exhaust Adaptor
A6. Connect Ductwork
A1.| ATTACH THE MOUNTING PLATE
TO THE WALL
Attach the plate to the wall using toggle bolts. At least
one wood screw must be used to attach the plate to a
wall stud.
Remove the toggle wings from the bolts.
Insert the bolts into the mounting plate
through the holes designated to go into drywall and
reattach the toggle wings to 3/4" onto each bolt.
12
To use toggle bolts:
Spacing for
_ Toggles More Than
»|++1.—Wall Thickness
[Toggle Wings
ua Toggle
" ig Bolt
", / |
Bolt End
Mounting
Place the mounting plate against the wall and insert
the toggle wings into the holes in the wall to
mount the plate.
NOTE: Before tightening toggle bolts and wood screw,
make sure the tabs on the mounting plate touch the
bottom of the cabinet when pushed
flush against the wall and that the plate is properly
centered under the cabinet.
ACAUTION: Be careful to avoid
pinching fingers between the back of the
mounting plate and the wall.
4] Tighten all bolts. Pull the plate away from the wall to
help tighten the bolts.