How To Set Up Jumper; Cpu Installation - Biostar P4TPE Pro Manual

User's Manual X 1
Fully Setup Driv er CD X 1
USB 2.0 Cable X 1 (optional)
S/PDIF Ou t/ In Cable X 1 (optional)
Rear I/O Panel f or ATX Case X 1

How to set up Jumper

The illustration shows how to set up a jumper. When the Jumper cap is placed on pins, the
jumper is "close". If no ju mper cap is placed on the pins, the jumper is "open". The
illustration shows a 3-pin jumper whose pin1 and 2 are "close" when jumper cap is placed
on these 2 pins.
Jumper open

CPU Installation

Step1: Pull the lever sidewa y s away from the socket and then raise the le v er up to a
90-degree angle.
Step2: Look f or the white do t/cut edge. The white dot/cut edge should point wards the lev er
piv ot. The CPU will f it only in the corre ct orienta tion.
Step3: Hold the CPU down f irmly, and then close the le ver to complete the installa tion.
Step4: Put the CP U Fan on the CPU and buckle it. Connect the CPU fan power cable to
the JCFAN1. This completes the installation.
Step 1
Jumper close
Step2 Step3
6
Pin1-2 close
Step4