Audi Q3 2017 Owner's Manual page 90

Table of Contents

Advertisement

Parking
systems
- If the position and the installation angle of
the rearview camera was changed, for ex-
ample after a collision, do not continue to
use the system for safety reasons . Have it
checked by an authorized Audi dealer or au-
thorized Audi Service Facility.
- Only use the rearview camera to assist you if
it shows a good, clear picture. For example,
the image may be affected by the sun shin-
ing into the lens, dirt on the lens, or if there
is a malfunction.
- Use the rearview camera only if the luggage
compartment
lid is completely closed. Make
sure any objects you may have mounted on
the luggag e compartment
lid do not block
the rearview camera.
- The camera lens enlarges and distorts the
field of vision. The object appears both al-
tered and inaccurate on the screen.
- In certain situations, people or objects in
the display appear closer or farther away:
- For objects that do not touch the ground,
such as the bumper of a parked vehicle, a
trailer hitch or the rear of a truck. Do not
use the orientation lines in this case.
- If driven from a level surface onto an in-
cline, or a downward slope.
- If driven toward protruding objects .
- If the vehicle is carrying too much load in
the rear .
Q)
Note
- Always read and follow the applicable warn-
ings
¢ (I)
in General information on
page 85.
- The orange-colored orientation lines in the
Infotainment
display show the vehicle path
based on the steering wheel angle . The
front of the vehicle swings out more than
the rear of the vehicle. Maintain plenty of
distance so that an exterior mirror or a cor-
ner of the vehicle does not collide with any
obstacles.
88
· Switching on/ off
Applies to: vehicles with parking system pl us with rearview
camera
Switching on
.. Shift into reverse, or
.. Press the
PwA
button in the center console
¢
page 86, fig. 89. A short confirmation tone
sounds and the LED in the button turns on .
Switching between the rearview camera and
optical display
.. Press the
Car graphic
control button ®
c:>
page 89, fig. 95 to see the optical display .
.,. Press the Rearview control button to see the
rearview camera image .
Switching off
.. Drive faster than 6 mph (10 km/h), or
.,. Press the
PwA
button, or
.. Switch the ignition off.
(D
Tips
The visual display in the left part of the dis-
play should help you detect the critical vehicle
areas .

Advertisement

Table of Contents
loading

Table of Contents