Advertisement
Available languages
Available languages
Wail Outlet
Location
12"4
i
m
10"
m
m
, Recommended
area for
' 120V grounded
outlet
I on rear wall.
22"
NOTE:
if an outlet
is not available,
[
have one installed
by
I
½
OF
UNIT
Figure 4
Clamp
Down
Information
Once the cooktop is installed in the counter opening, you
must clamp tile unit down as shown.
Foam
Countertop
Thumb
Screw
Figure 5
Provide
an Adequate
Gas
Supply
This cooktop is designed to operate on natural gas at 4"
of manifold pressure only.
A pressure regulator is connected in series with the
manifold on the cooktop and must remain in series with
the supply line.
For proper operation,
the maximum inlet pressure to
the regulator must be no more than 14" of water column
(W.C.) pressure.
For checking the regulator, the inlet pressure must be at
least I" (or 2.5 kPa) greater than the regulator manifold
pressure setting. The regulator is set for 4" of manifold
pressure, the inlet pressure must be at least 5".
Tile gas supply line to the range should be 1/2" or 3/4"
pipe.
LP/Propane
Gas Conversion
This appliance can be used with Natural gas or LP/
Propane gas. It is shipped from the factory for use with
natural gas.
A kit for converting to LP gas is supplied with your
cooktop. The kit is marked "FOR LP/PROPANEGAS
CONVERSION".
The conversion must be performed by a qualified service
technician in accordance with the kit instructions and all
local (:odes and requirements. Failure to follow
instructions could result in serious injury or property
damage. The qualified agency performing this work
assumes responsibility for the conversion.
Failure to make the appropriate
conversion can result in serious personal injury and
property damage.
To (:lamp down, insert the bracket with tile offset side of
the angle into the slots on each side of the unit. The
thumb screw should then be run through the bracket, up
against the bottom of the counter. Tighten until the unit
draws down.
Advertisement
