Advertisement
Available languages
Available languages
Important
Notes
to the
Installer
1.
Read all instructions contained in these installation
instructions before installing the cooktop.
2.
Remove all packing material before connecting the
electrical supply to the cooktop.
3.
Observe all governing codes and ordinances.
4.
Be sure to leave these instructions with tile consumer.
5.
Note; For operation at 2000 ft. elevations above see
level, appliance rating shall be reduced by 4 percent
for each additional 1000 ft.
Important
Note
to the
Consumer
Keep these instructions with your Use and Care Guide for
future reference.
IMPORTANT
SAFETY
NS
Installation of this cooktop must conform with local codes
or, in the absence of local codes, with the National Fuel
Gas Code ANSI Z223.1--1atest
edition in the United
States, or in Canada, with the Canadian Fuel Gas Code,
CAN/CGA B14g and CAN/CGA B149.2.
This cooktop has been design certified by CSA
international.
As with any appliance using gas and
generating heat, there are certain safety precautions you
should follow. You will find them in tile Use and Care
Guide, read it carefully.
Be sure your cooktop
is installed
and grounded
properly
by a qualified
installer
or service
technician.
This cooktop
must be electrically
grounded
in
accordance
with
local codes or, in their absence,
with the Nationat
Electrical Code ANSUNFPA No.
70--Jatest
edition
in the United States, or in
Canada, with the Canadian Electrical Code, CSA
C22.1 Part 1.
• The burners can be lit manually
during
an
electrical
power
outage.
To Hght a burner,
hold a
lit match to the burner
head, then slowly
turn the
Surface Control
knob to LITE. Use caution
when
lighting
burners
manually.
Do not store items of interest
to children
in
cabinets above the cooktop.
Children could be
seriously burned climbing on the cooktop to reach
items.
To eliminate
the need to reach over the surface
burners, cabinet storage space above the burners
shoutd be avoided,
Adjust
surface burner flame size so it does not
extend beyond
the edge of the cooking
utensil,
Excessive flame is hazardous.
Never use your cooktop
for warming
or heating
the room. Prolonged use of the cooktop without
adequate ventilation can be hazardous.
• Do not store or use gasoline
or other flammable
vapors and liquids
near this or any other
appliance,
Explosions or fires could result.
The electrical
power
to the cooktop
must
be shut
off while
gas line connections
are
being
made.
Failure
to do so could
resutt
in serious
injury
or death.
Before
Installing
the Cooktop
8_U_D
Foam
P
Glass
Film
Figure
2
A roll of foam tape is supplied and packed in the
literature package. Install the tape around tile perimeter
of the metal flange of the burner box, at a distance of
1/4" from the outer edge. Apply tile exposed adhesive
side of tile tape against the metal flange (see figure
above). Remove the protective
film from the
underside
of the tape before
inserting
the cooktop
into the countertop
opening.
NOTE: This tape seals the underside of the cooktop to
the counter. Do not remove this foam tape. This tape
prevents entry of air that may interfere with proper gas
combustion, and prevents liquids from leaking under tile
cooktop.
Insert cooktop into countertop cutout so that full width of
tape seals to cutout edge. NOTE; To avoid injury and
product damage, only suspend cooktop from cutout by
means of cooktop metal flange. Never suspend cooktop
from cutout by means of cooktop glass edges.
Advertisement
