Know Your Chain Saw; Throttle Trigger - Poulan Pro PPB3416 Instruction Manual

Adjusting
Screw
3. Using bar tool, roll chain around guide bar
to ensure all links are Jn bar groove.
4-. Uff up tip of guide bar to check for sag.
Release tip of guide bar, then turn ad-
justing screw 1/4 turn clockwise. Repeat
until sag does not exist.
Adjusting Screw - _/4 Turn
5. While lifting tip of guide bar, tighten bar
nuts securely with the bar tool.
KNOW YOUR CHAIN SAW
6 Use the screwdriver end of the bar tool
to move chain around guide bar.
7 if chain does not rotate, it is too fight.
Stight]y loosen bar nuts and loosen
chain by turning the adjusting screw 1/_
turn counterclockwise. Retighten bar
nuts.
8 ff chain is too loose, it will sag betow the
guide bar. DO NOT operate the saw if
the chain is loose.
_,WARNING:
If the saw is operated
with a loose chain, the chain could jump off
the guide bar and result in serious injury.
READ THiS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR
CHAIN SAW Compare the illustrations with your unit to familiarize yourself with the location of
the vadous controls and adjustments. Save this manual for future reference.
Chain Front Hand Guard
Adjustment Toot
(Bar Tool) _ Starter Rope
ON/STOP
Switch Choke/
Chain Muffler
Lever
Bar Bar Oil Fill Cap
Sprocket
Hote
Throffte
Lockout
Rear
Handle
Cylinder Cover
Starter Housing Fuet Mix FiI[ Cap
Chain
Primer Butb
Chain
Direction
of Travel
Throttle Ctutch Cover
Trigger Bar Nuts
Guide Bar
Catcher
ON/STOP SWITCH THROTTLE TRIGGER
The ON/STOP SWITCH is used to stop the The THROTq'LE TRIGGER controls engine
engine speed.
8